SDS

Usage and safety instructions
The battery consists of lithium, organic solvent and other flammable materials.
Proper handling of batteries is crucial. Otherwise, the battery may cause deformation,
liquid leakage (accidental leakage of liquid), overheating, explosion, fire, personal
injury to others or damage to equipment. Please strictly follow the following
instructions to avoid accidents.
Warning matter
· Do not swallow
In order to prevent children from easily taking in batteries and putting them in
their mouths, batteries should be stored away from them. However, if all this
When it happens, you should take them to the hospital immediately.
· Non-rechargeable
The battery is not a rechargeable battery. You should not charge it because it may
cause internal short circuit and gas generation.
Causing deformation, leakage, overheating, explosion, or fire.
· No heating
If the battery is heated above 100 degrees Celsius, it will increase the internal
pressure, causing deformation, leakage, overheating, explosion, or fire. · No burning
If the battery is burned or exposed to flame, lithium metal will melt, causing
explosion or fire.
· Do not disassemble the battery
Non-professionals are not allowed to disassemble batteries. Because it will cause
sealing ring damage, deformation, leakage, overheating, explosion, or fire. · Avoid
improper setup
Improper setting may lead to forced discharge of the battery. It may cause battery
deformation, leakage, overheating, explosion, fire and other adverse consequences.
When set, the positive and negative terminals of the battery should not be connected
backwards.
· No short-circuit battery
Direct connection between the positive and negative terminals of the battery should
be avoided. If the metal items you carry or keep come into contact with the battery,
the battery may
Deformation, leakage, overheating, explosion or fire occur.
· Do not solder batteries directly
Welding will cause the battery to increase heat, damage the sealing ring and melt
lithium, damaging the battery. May lead to leakage, overheating, explosion or lead
A fire broke out. The battery should not be soldered directly to the equipment, it must
be connected by connecting pieces or wires. The temperature of the soldering iron shall
not exceed 50 centigrade.
The degree and welding time shall not exceed 5 seconds; It is important to keep the
temperature low and the time short. When not soldering, do not put the battery in the
soldering