User Manual

November 1999
M68333 Rev. A Tel-Link PMP - Sector Terminal Installation & Maintenance Manual 1-1
1.0 General Information
Before installing and operating a Tel-Link Point to Multipoint (PMP) System, P-COM recommends
installation personnel read this section in its entirety. Once accomplished, the user can proceed directly to
the section or subsection of interest.
This manual provides the installation procedures and guidelines for installing hardware associated with a
PMP System. This manual is intended for personnel who are responsible for installing and testing the PMP
system. The user should keep this manual next to the system at all times.
P-COM highly recommends the user utilize the P-COM PMP Installation Procedure Checklist located in
Appendix A to ensure the correct procedures are followed. For further assistance, contact the P-COM
Technical Assistance Center (TAC) at 1-877-674-3600.
1.1 Manual Organization
This manual is part of a set of PMP manuals that focus on specific aspects of the PMP system. The set of
manuals consist of the following:
• M68330 - Tel-Link PMP System Description Manual
• M68331 - Tel-Link PMP Local Site Manager Users Manual
• M68332 - Tel-Link PMP Network Management System Users Manual
• M68333 - Tel-Link PMP Sector Terminal Installation & Maintenance Manual
• M68334 - Tel-Link PMP Remote Terminal Installation & Maintenance Manual
The Manual is divided into 12 sections providing specific information needed to install and test the PMP
System. The sections are:
Section 1: General Information - Contains discussions on
the use of this manual, summary of the manual,
special notations, and general safety reminders
Section 2: Sector Terminal Overview - Provides a descrip-
tion of the PMP equipment.
Section 3: Tools and Test Equipment Required - Provides
lists of tools and equipment necessary to perform
the installation.
Section 4: Site Preparation - Contains information on how to
prepare the installation site.
Section 5: Equipment Unpacking and Inspection - Provides
instructions on how to unpack and inspect the
PMP Equipment
Section 6: Sector Terminal Outdoor Unit Installation - Pro-
vides instructions on how to install the Outdoor
Unit.