User Manual

November 1999
M68333 Rev. A Tel-Link PMP - Sector Terminal Installation & Maintenance Manual 6-1
6.0 Sector Terminal ODU Installation
6.1 Introduction
This procedure provides instruction for installing a P-COM Tel-Link Point to Multipoint Sector Terminal
ODU/Antenna assembly.
6.2 Tools Required
Multiple vendors of antenna and mounting assemblies may be used to operate with the P-COM PMP ODU.
A listing of tools necessary to install an antenna/mounting assembly, can be found in the vendor's antenna
installation manual.
6.3 Materials Required
• Antenna/mounting assembly. This assembly typically includes all hardware needed to install
the antenna to the mount, and the mount to a pole.
• Outdoor Unit (ODU)
6.4 Sector Terminal ODU/Antenna Installation Procedure
WARNING! Failure to follow installation procedures may result in damage to the ODU/Antenna and
render the radio unusable. Read through the entire procedure before attempting
installation. If there are any questions, please contact P-COM Technical Assistance Center
(TAC) at 1 [phone].
STEP 1. Install the Mounting Bracket on the pole with the elevation adjusting screw either at the
top or bottom of the mount, depending on the desired angle of the Sector Antenna rel-
ative to the Remote sites (refer to Figure 6-1).