User Manual

November 1999
6-2 M68333 Rev. A Tel-Link PMP - Sector Terminal Installation & Maintenance Manual
Figure 6-1 - Mounting Bracket Assembly
STEP 2. Tighten the four retaining nuts on the backplate of the Mounting Bracket. The backplate
must be positioned such that it is perpendicular to the center point of the desired sector
field of view (refer to Figure 6-1).
STEP 3. Attach the Antenna Mount Assembly to the Mounting Bracket by securing two bolts at
the pole adaptor assembly. Insert the threaded rod from the pivot assembly into the
Elevation Adjusting Knob. This will control the amount of elevation induced (refer to
Figure 6-2).
Back Plate
Pole Adaptor
Assembly
Elevation
Adjusting
Gauge