Installation Manual User guide

ULTRA ADVANTAGE SERVO ROLL FEED 6/ 3/2002
8
FIGURE 4
10. Open the Feed Cam screen. Continue to jog the press slowly until the longest pilot just comes out of the
material. Note the press positional readout and put this setting for the ‘Feed Cam On’ setting. Set the ‘Feed
Cam Off’ point so that there is enough time to complete the feed length and enough time to stop the press, if
there is a feed fault. (See Figure 5.)
11. Open the Reset Cam screen and set the ‘Reset Cam On’ for 180 degrees and ‘Reset Cam Off’ for 200 degrees.
This setting should never need changing. (See Figure 5.)
1.5 THREADING THE TOOL
For a comprehensive description, refer to the Ultra Advantage Servo Roll Feed Operation Manual.
NOTE ABOUT CAMS:
The Feed Cam (open tool): The feed system uses this press cam for timing the feeder to the press crankshaft.
Although no shafting or belts actually connect the press to the feeder, the feed must be “told” when it is safe to
move the strip and when the feed move must be completed.
• This “connection” is an electrical one, and not a mechanical one. This gives the Operator/set-up personnel
total flexibility in deciding when the feed progression should take place.
• Each die set can have a unique ‘Feed Angle’. This ‘Feed Angle’ is dependent upon many variables; pilot and
punch length, press stroke, strip forming in the die, etc.
Put the Ultra Advantage control into “JTL” mode. All the adjustments to the feed system and press have now
been made. The press is at Top Dead Center (TDC) and ready for automatic cycling. Proceed by advancing the
material using Jog Forward button on the jog pendant until WAITING FOR PRESS is seen in the display and
inch the press through another stroke, verifying that things are happening at the correct time (Roll Release, etc.).
If the system is operating properly, you can make a few more “hits”, checking your parts.