Installation Manual Instruction Manual

ULTRA EDGE SEQUENTIAL SERVO ROLL FEED 6/3/2002
8
it up by the blade.
In this case the wiring must be considered very carefully.
The backing up the material in a Press application requires:
- A cutter bottom position sensor to be wired to the control.
The backing up the material in a Punching Bench application requires:
- A cutter bottom position sensor to be wired to the control:
- A cutter top position sensor to be wired to the control.
For a comprehensive description, refer to the Ultra Edge Servo Roll Feed Operation Manual and electrical
schematic A-18219-06.
1.6 RUNNING THE FEED
Put the Ultra Edge Sequential into “Auto” by pressing the Cycle Start button. The Ultra Edge
Sequential Servo Roll Feed will now follow the press until it is stopped by the Operator,
counter, emergency stop, or feed error.
TYPICAL 180 DEGREE FEED ANGLE (FROM 260 DEGREES TO 80
DEGREES) WITH MECHANICAL PILOT RELEASE IN A POWER PRESS
APPLICATION:
FIGURE 5