User guide

ULTRA EDGE SERVO ROLL FEED 2/14/2003

NOTE: To exit setup editing at any time, press the “OPER” key. Changes will be saved.

4 HOW TO …

NOTE: Make sure that the PROGRAMMING “LOCKED / UNLOCKED” key switch is in “Unlocked”

position. If the current screen is one of the tool editing screens (they all have the message on the last line “Press

TOOLS for next”), press the “OPER” key to exit tool editing.

4.1 HOW TO CREATE A NEW TOOL

Press the “TOOLS” key.

Position the pointer next to Create new tool command and press the “ENTER” key.

E d i t T o o l

A c t iv a t e T o o l

C r e at e N e w <

P r e ss T O O L S t o E x i t

Enter new tool number and press the “ENTER” key again.

C r e at e T o o l #

P r e ss T O O L S t o E x i t

C r e at e # 1

LINEAR

ACCELERATION

S-CURVED

ACCELERATION