Owner manual

OPERATION:
1. Connect air hose to compressor and 200T-000 Spray Gun. Make sure couplings are wrench tight.
a. PTFE tape can be added to the male connections on the spray gun and air compressor to help
prevent any air leaks. Air leaks will decrease air pressure to the spray gun.
2. a. If your compressor has a regulator, set pressure to 11-15 psi.
b. We recommend using the Paasche D200 or DA400R Air Compressor.
3. Adjust Fluid Knob on the Spray Gun until desired spray is reached.
4. Sprayer should be held 10-12 inches from area being sprayed.
5. To Clean, fill bottle with hot water and spray for several seconds into an absorbent container.
INSTRUCTIONS AND PARTS LIST 200T-00-8/31/2011
Supersedes Instructions & Parts List 200T-000--9/2008
WARNING: Consult the product label
and Material Safety Data Sheet if
supplied for the spray material. Follow
all recommended safety precautions.
Well Ventilated Area Required to
remove fumes or overspray.
Maximum Air Pressure 70 P.S.I.
Printed in the U.S.A.
Paasche Airbrush Company
4311 North Normandy Avenue
Chicago, IL 60634-1395
Phone: [phone] • Fax: [phone]
Website: paascheairbrush.com
E-Mail: [e-mail]
Model 200T-000
Tanning Spray Gun
OPERATING INSTRUCTIONS AND REPLACEMENT PARTS
AU-000 Tip
ANFA-000 Aircap
Fluid Adjusting Knob
200-1/2PT
Pressure Cup
Assembly
Air Inlet for Air
Hose Connection
200-29 Regulator Nipple
200-31 Check Valve