Instructions / Assembly

INSTRUCTIONS AND PARTS LIST, LMS-2-14 2/7/2018
WARNING: Spray materials may be harmful if inhaled or allowed
to come into contact with skin or eyes. Consult the product label
and Material Safety Data Sheet supplied for the spray material.
Follow all safety precautions. CAUTION: Well Ventilated
Area Required to remove fumes, dust or overspray. Check
compatibility of materials used with Polyethylene container
and PVC Fluid Hose. Secure airhose and fluid hose
wrench tight for safety and to prevent leaks.
Maximum Air Pressure 80 P.S.I.
Maximum Fluid Pressure 45 P.S.I.
LMS-2-14
DUAL FLUID SPRAY GUN
OPERATING INSTRUCTIONS AND REPLACEMENT PARTS
INTRODUCTION:
This Manual Spray Gun requires clean dry air regulated
from 6 to 8 C.F.M. at 45 to 60 lbs. air pressure depending on
the size of atomizing heads to be used. Paasche Regulator
& Condenser Units are recommended for attaching to air
supply line to remove water, oil, rust or scale and help
insure a quality nish of coating.
AIR AND FLUID CONNECTIONS:
1. Air Connection: To remove any accumulated foreign
matter blow out all hoses before using.
a. Air supply to Spray Gun must be turned off
before attaching ttings to the Air Inlet.
b. Attach HT-1/4 Air Hose to the Air Outlet on the
Air Regulator and Air Inlet on the bottom of the
handle on the Spray Gun.
2. Fluid Hose: Use LM-10S Fluid Hose with Stainless
Steel Connections . Run hose from Spray Gun to
Pressure Pot or Gravity Cup.
a. Attach LM-14S Nut and Nipple, Stainless Fittings,
to the uid inlets of the two Fluid Bodies.
3. Fluid Container Connection: When using USP-QT
(QT./.946 l) Plastic Bottle Assemblies, make sure
Screw Covers are tightened securely so uid will not
leak at Bottle connections.
4. Tighten all Air and Fluid connections securely.
OPERATION:
1. After hose connections have been made, regulate the
air pressure to about 45 lbs. and then pull trigger back
slowly.
a. The rst 1/4” of trigger stroke opens the Air
Valve which operates both the cylinders.
b. Continued pull on the trigger opens both
of the atomizing Spray Heads for spraying.
2. The U-3670 Adjusting Knob (part# 25) can be used
to regulate desired amount of uid to the automatic
Spray Head.
3. Dual Fluid Spray Guns are designed to atomize and
mix uid materials outside the atomizing aircaps.
This prevents materials from hardening inside the
spray gun.
4. The 59-30 PTFE Packing Assembly (part# 19) should
be replaced periodically.
Paasche Airbrush Company
4311 North Normandy Avenue
Chicago, IL 60634-1395
Phone: [phone] • Fax: [phone]
Website: paascheairbrush.com
E-Mail: [e-mail]
Printed in the U.S.A.
Applications: Silvering Mirrors, Chroming Dual Material Applications.