Instruction Manual

Speaker Connection Harness for Select
Toyota and Lexus Vehicles with Factory Ampliers
Equipped with a 10-Pin and 12-Pin Connector
APH-TY04
Pacific Accessory Corporation
Page 1
Copyright © 2019. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Rev: V1
Date: 010419
Introduction and Features
The APH-TY04 simplies speaker wire connections when adding aftermarket ampliers. Aftermarket ampliers can
be easily added with no need to cut or modify a vehicle’s original wiring. Each pair of wires has been labeled with the
corresponding speaker name.
Wiring Overview
Installation Notes
1. It is always best to use a tone generator (PAC part number: TL-PTG2) to verify that the tables in this manual, and the labels
on the wires, match the wiring in your specic vehicle. This is important as there are instances where different trim levels of
the factory system may have the speaker outputs in different locations.
2. Any factory amplier connectors other than the 10-pin and 12-pin connectors used by the APH-TY04, must remain
connected to the factory amplier when using a PAC AmpPRO Interface. The PAC AmpPRO Interface will not operate
properly without them connected.
3. Not all applicable vehicles will come equipped with a corresponding speaker for all of the wires populated in our harness. It
is important to understand which speakers are equipped in your vehicle.
4. If you are leaving any of the factory speakers connected to the factory amplier, simply connect the speaker wires (color for
color) between the male and female connectors, for the speakers that will be powered by the factory amplier. For example:
If you want the rear speakers to be powered by the factory amplier, simply connect the Green, Green / Black, Purple and
Purple / Black wires from the male connector to the Green, Green / Black, Purple and Purple / Black wires from the female
connector.
5. For vehicles that lose audio output when there is no load on the speaker outputs of the factory amplier, PAC load resistors
will be required (PAC Part Number LR335 or LR475).
1. Locate the vehicle’s factory amplier and disconnect the 10-pin and 12-pin connectors.
2. Connect the APH-TY04 harnesses to the connectors that were disconnected in the previous step.
3. Connect the male connectors from the APH-TY04 to the amplier.
4. Connect the longer loose wires from the APH-TY04, to your aftermarket amplier outputs or passive crossovers, according
to the tables in this manual.
5. Insulate unused wires in the 10-pin and 12-pin connectors that plug into the factory amplier side of the APH-TY04.
Installation Steps
Insulate any unused wires
Blue / Black
Blue
Red
Green / Red
Yellow / Red
1
610
7
Red / Black
Brown
Green / White
Yellow / Blue
Brown / Black
APH-TY04-HAR 10P A
6
1
10
7
Yellow / Blue
Yello
w / Red
Green / Red
Red
Blue
Green / White
Brown / Black
Red / Black
Blue / Black
Brown
APH-TY04-HAR 10P
B
1
Blue / Black
Subwoofer 2 -
7
Blue Subwoofer 2 +
2
Red / Black
Subwoofer 1 -
8
Red Subwoofer 1 +
3
Brown / Black
Speaker 3 -
4
Brown Speaker 3 +
5
Green / White
Speaker 1 -
9
Green / Red Speaker 1 +
6
Yellow / Blue
Speaker 2 -
10
Yellow / Red Speaker 2 +
Speaker 2
Subwoofer 2
Subwoofer 1
Speaker 3
Speaker 1
Pin Number Wire Color Wires Description
Label
APH-TY04 10-Pin Connector
Connect to aftermarket amplier
output or passive crossover.