Instruction Manual

PAC-audio.com

Pacific Accessory Corporation

Rev.7

1/5/2022

LPH Harness Instruction Guide

Wiring Connection Chart (All Models)

MODELS:

• LPA-E4

• LPA2.4 / LPA2.2

• LPA1.4 / LPA1.2

Important Note: This harness is provided

with a inline fuse installed. Please remove

prior to install and reinsert once nished.

If your vehicle does not provide ACC

source your harness will not have a

"RED" wire to connect.

It will use DC O󰀨set to turn on as well

as trigger the "REM OUT" on the LPA.

On LPA-E4 there will be a jumper that

you can move based on your application.

This harness is designed to work on

OEM NON-AMPLIFIED systems.

Connect the RED BUTT Connector to

the aftermarket system turn on for your

ampliers.

Fully open terminals

before inserting wire.

PAGE 1
LPH Harness Instruction Guide Wiring Connection Chart (All Models) MODELS: • LPA-E4 • LPA2.4 / LPA2.2 • LPA1.4 / LPA1.2 Important Note: This harness is provided with a inline fuse installed. Please remove prior to install and reinsert once finished. If your vehicle does not provide ACC source your harness will not have a "RED" wire to connect. It will use DC Offset to turn on as well as trigger the "REM OUT" on the LPA. On LPA-E4 there will be a jumper that you can move based on your application.
PAGE 2
LPH Harness Instruction Guide Example Installation - 4-Channel Amplifier - (HARNESS CUT REQUIRED) AFTERMARKET AMPLIFIER • Cut the harness close as possible to the "CUT HERE AND INSULATE" label. You must insulate wires to prevent damage to OEM radio. • The cut speaker wires will need to be connected to your aftermarket amplifier. (REFER TO LABEL ON HARNESS) • Please refer to the chart on the first page for wiring your loose wires to your LPA. • This harness is designed to work on OEM NON-AMPLIFIED systems.