Instruction Manual

Complete Radio Replacement with
Integrated Climate Control Retention for Select
2014–2020 Jeep Grand Cherokee
RPK4-CH4103
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 16
Rev: v.1
Date:041020
Setup and Testing (cont.)
Camera Setup
The camera settings menu is used to set up which cameras are installed on the vehicle. When used with the PAC harness
RPA-16P5V (sold separately), the RPK4-CH4103 gives you the ability for switching via the 5.2” LCD and automatic triggers
for up to 5 di󰀨erent camera images to display on the aftermarket radio. Note: Camera 1 is permanently set as the Rear
Camera and cannot be changed in the settings menu. Camera inputs 2, 3, 4 and 5 can be toggled between “None” (no
camera) or the options shown in Fig. 1 below.
Trailer
Bed
Front
Camera
Left
Camera
Aux
Camera
Trailer Left
Camera
Trailer Right
Camera
Camera Options
Right
Camera
Nanny
Camera
Verify that the buttons are correct on the display,
and match the buttons and button positions on
the new dash panel. If the layout matches, press
“Looks good” to complete the vehicle accessories
buttons setup. If it does not match, press “Go
back” to perform the setup again.
Step 4
If the vehicle is equipped with the button shown,
press that button on new dash panel. If not
equipped, press “I Do Not Have This Button”.
Once the button is programmed, a di󰀨erent
button will be displayed. Continue this process
until the verify conguration screen is displayed.
Step 3
Open the Buttons Setup Wizard
Open Installer Settings
Step 1
Vehicle Accessories Buttons Setup
Step 2
Because the vehicle accessories buttons that are used vary from vehicle to vehicle, the accessories buttons must be congured to
the position in which they are installed. Some vehicles will have fewer installed accessories, so instead of a button there will be a
blank installed. Conguring a button that was not present on the factory dash panel will not add features to the vehicle.
Fig. 1
Rear
Camera
Camera 1
(Locked)
Cannot Be
Changed