Instruction Manual

Complete Radio Replacement with
Integrated Climate Control Retention for Select
2014–2020 Jeep Grand Cherokee
RPK4-CH4103
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 22
Rev: v.1
Date:041020
Firmware Updates
The RadioPRO app will allow you to update the RP4.2-CH4103 interface module with new rmware as it becomes available.
Please visit www.PAC-audio.com/rmware to download available updates.
The radio dash bezel can also be updated. Refer to the RPK4-CH4103 User Manual for additional information.
To update the RadioPRO interface module, open the Radio PRO PC app, connect the interface to your PC and select
”Firmware” and then “Update Firmware”.
Product Updates (Firmware)
Reset / Restoring Interface Factory Settings
You can restore the interface to factory default settings by pressing and holding the programming button on the side of the
module until the status LED starts blinking red. Once the LED starts blinking red, release the button. You must release the
button while the LED is blinking red in order to perform the reset. This reset will restore all settings to factory defaults.
Email: [e-mail]
Phone: [phone]
International: 727-592-5991
Technical Support
Now, select “Select File”. Finally, browse to the place where you saved the le, and select it. This will begin the updating
process. Once nished, disconnect the interface from the PC and test operation.