Instruction Manual

Complete Radio Replacement with
Integrated Climate Control Retention for Select
2014–2020 Jeep Grand Cherokee
RPK4-CH4103
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 3
Rev: v.1
Date:041020
Disconnect the 52-pin dock and
lock connector and all of the
antennas from the radio (the
number of antenna connections
will vary based on the vehicle’s
available features).
Part One: Disassembly of Factory Dash / Dash Prep. (Cont.)
Remove the four 7mm screws
securing the radio in place.
Remove the radio from the dash
(dash appearance may vary
according to model year).
Step 3 Step 4
Step 5
Section A: 2014 - 2017 Grand Cherokee (Screen is Part of Radio)
Disconnect the harness that is
plugged into the back of the dash
panel and set the dash panel
aside.
Step 2
Remove the three 7mm screws
securing the AC / Heater Control
Module in place.
AC / Heater Control
Module
Step 6
Keyless Entry Antenna
Located Below
Relocating the AC / Heater
Control Module (Steps 6–10)
Only necessary for installation in
2014–2017 Grand Cherokee and
only if there are problems with
the depth of the aftermarket radio.
(Not necessary if installing a
shallow-mount radio)
To relocate the AC / Heater Control Module, it is necessary to release
the clip that holds the harness of the module in place. To access the
clip, remove the two 7mm screws that hold the Keyless Entry Antenna
in place (if available).
Step 7
Keyless Entry Antenna