Instruction Manual

Complete Radio Replacement with
Integrated Climate Control Retention for Select
2014–2020 Jeep Grand Cherokee
RPK4-CH4103
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 5
Rev: v.1
Date:041020
Removing the Vents from the Factory Dash Panel
The vents must be removed from the factory dash panel for reuse with the RPK4-CH4103. To remove the vents, use a
pick tool or small athead screwdriver to release the bottom vent tabs, and slightly pull the bottom of the vent away from
the dash panel. Do the same with the side vent tabs. With the bottom and side tabs released, release the locking tabs on
the top vent as you pull the vent straight out and away from the dash panel. The factory dash panel can now be stored
away for use when it is time to reinstall the factory radio.
Release Locking Tabs
Bottom Vent
Tabs
Release Locking Tabs
Side Vent Tabs
Locking Tabs
Securing Points
Locking Tabs
Vent Positioning Hooks
Vent Positioning Slots
Top Vent Tabs Top Vent
Securing
Points
Release Locking Tabs
Pull Vent
Top Vent
Tabs
Section B: 2018 and Up Grand Cherokee (Screen is Part of Dash Panel)
Remove the four 7mm screws
securing the radio module in place.
Disconnect the harnesses that
are plugged into the back of the
dash panel, and set the dash
panel aside.
Disconnect the 52-pin dock and
lock connector and all of the
antennas from the radio (the
number of antenna connections
will vary based on the vehicle’s
available features).
Step 2 Step 3 Step 4
Part Three: Installing the New Dash Panel
Part Two: Radio removal / Dash preparation (cont.)