Instruction Manual

Complete Radio Replacement with
Integrated Climate Control Retention for Select
2014–2020 Jeep Grand Cherokee
RPK4-CH4103
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 6
Rev: v.1
Date:041020
Installing the Vents from the Factory Dash Panel
Vent Positioning Hooks
Outermost Bottom
Locking Tab
Outermost Bottom
Locking Tab
Vent Positioning Slots
Side Tabs Side Tabs
1
3
2
4
6
7
5
1
3
2
4
1
2
3
4
Depending on the accessories
installed on the vehicle, there may
be up to 7 functioning buttons below
the climate controls. Only the options
available on the factory dash panel
will operate with the RPK4-CH4103.
Inserting buttons with icons that do
not match the factory buttons will not
add features to the vehicle.
Sort through the included
RPK4-CH4103 loose buttons and
set aside the ones that match the
buttons on the factory dash panel
and a blank button / buttons (when
necessary) for a total of 7 buttons
that will be installed into the new
dash panel. The leftover buttons will
not be used.
The buttons will be programmed later
(see page 16), so their arrangement
in the new dash panel is a matter
of customer preference. The top
of the blank is easily noted by the
line on the side. Loosely slide the
buttons into the desired opening, but
make sure you are satised with the
positions prior to seating them fully
into the kit. The buttons are di󰀩cult to
remove once they are fully seated.
Step 3
Step 2
Installing Vehicle Accessories Buttons and Auto Climate Button
Part Three: Installing the New Dash Panel
The RPK4-CH4103 comes with a
“Blank” and an “Auto” button insert
for the fan speed knob. The Grand
Cherokee always comes with the
auto HVAC function, so install the
insert that says “Auto”. Be sure to
line up the light pipe with the hole in
the kit, and then push the button into
place.
Step 1
Blank Insert
Top
Bottom Wider
Than Top
FrontBack
Blank Blank Blank
Step 4