User Manual

Installer Facilities
17047 Ver 1.8 DRAFT C 24 Easikey® 1000
8.5 Anti-Passback
When two readers are used to control both entry into an area and exit out of the area, anti-
passback may be set. This will prevent a key being used to enter an area it has already been
used to enter first leaving the area. If an attempt is made to use the key to enter the area again,
a No Access: Pass Back report will be generated on the printer. As with channel interlock,
channel 1 is considered the entry reader and channel 2 the exit reader.
Passback may either be active until the key is used to leave the area, or a time limit may be
assigned after which the key may be used to enter the area again. The time limit is useful if
people are likely to leave the area without using their keys, without the time limit they would be
unable to get back in the area.
Step Example Display Action
1 Present an editor key to the controller reader.
2
SEL?
Press INST/9.
3
SetC
Press Ð 4 times.
4
P00 or
P00. if Channel
Interlock is set.
Type a value followed by SEL/SAVE.
0 No pass back
1 Pass back with no time limit.
2-60 Number of minutes after which a key will work again if
it is not used to leave the area.
5
P15 (with an anti-
passback time set
to 15 mins)
6
SEL?
Press ESC to leave Editor mode.
8.6 Software Version Display
It may be useful at times to verify the software version used in the controller. You may be
asked for this by PAC Technical Support.
Step Example Display Action
1 Present an editor key to the controller reader.
2
SEL?
Press INST/9.
3
SetC
Press Ð 5 times.
4
v100
In this case version 1.00 is displayed. Press ESC.
5
SEL?
Press ESC to leave Editor mode.