User Manual

Displays and Alarms
17047 Ver 1.8 DRAFT C 27 Easikey® 1000
10. Displays and Alarms
The Easikey 1000 door controller will display various characters on its 4-character screen and
produce a sound as a response to certain conditions. These are described below.
Also included in this section are example printer reports produced when a printer is attached to
an Easikey 1000.
10.1 Power Indicators
When not in Editor mode (to add/delete keys, etc.) the red and green LEDs are used as power
indicators as follows:
• The red LED is constantly lit indicating that ac supply is healthy.
• The green LED is constantly lit when the battery (if any) is low (less than 12V).
These are not referred to elsewhere in the document and it is assumed that power is supplied to
the unit.
10.2 Normal Displays
When nothing is happening, the display is blank and no sounds are produced.
Whenever a door is opened normally, either with a key or by using a Request to Exit switch,
the display will show:
Door 1 Open Door 2 Open Both Doors Open
Printer Example
DATE TIME DOOR USER TRANSACTION
[0123] 12/06/95 10:34 1 0092 Access Authorised
[0124] 12/06/95 10:35 2 Request to Exit
[0125] 12/06/95 10:50 2 Manual Unlock
[0126[ 12/06/95 13:30 1 Automatic Unlock
10.3 Door Left Open Warning
This warning will only be given if door monitoring is being used - check with the installer of the
system to see if this is the case.
If a door is left open longer than the time set, the
oP(shown above) will start to flash for the
particular door left open. The
oP will continue to flash until the door is closed. There is no
sound associated with this warning.
Printer Example
DATE TIME DOOR USER TRANSACTION
[0233] 12/06/92 12:34 1 Door Left Open
[0234] 12/06/92 12:35 1 Door Closed