User Manual

Displays and Alarms
17047 Ver 1.8 DRAFT C 28 Easikey® 1000
10.4 Unauthorised Access Alarm
This alarm will only be given if door monitoring is being used - check with the installer of the
system to see if this is the case.
If a door is opened without a key being used, time profile being active, manual unlock used or a
Request to Exit switch being pressed, the controller interprets this condition as
Unauthorised Access. In this case, the alarm has to be accepted by presenting an editor
key to the controller reader.
This alarm gives exactly the same displays and sounds as for Cable or Reader Tamper
alarm (see Section 10.6). However, the printer report is different.
Display AL, Flashing
Sound Every 2 seconds
Unauthorised access or cable tamper.
Present editor key to accept, the sound will stop.
Display AL, Steady
Sound Silent
Accepted alarm or cable/reader tamper.
The alarm condition still exists, either the door is still open or the
cable/reader is still tampered.
Printer Example
DATE TIME DOOR USER TRANSACTION
[0278] 12/06/92 13:34 1 Unauthorised Access
[0282] 12/06/92 13:35 1 MASTER Local Alarm Accepted
[0285] 12/06/92 13:37 1 Alarm Cleared
10.5 Duress Alarm
This alarm will only be given if a PIN reader is being used and the keyholder is forced to open
the door under duress. If the PIN is, for example, 1234, the keyholder may enter 1235 instead.
This will open the door but send a code to the controller indicating that the door has been
opened under duress.
The alarm generated at the controller is as follows:
Display dU, Flashing
Sound Every 2 seconds
PIN Code Duress.
Present editor key to accept the alarm; the sound will stop and
display will clear.
Printer Example
DATE TIME DOOR USER TRANSACTION
[0278] 12/06/92 13:34 1 PIN Code Duress
[0282] 12/06/92 13:35 1 MASTER Local Alarm Accepted