User Manual

15162 Ver 2.8 DRAFT E Central Network Controller Installation Guide
Page 32 © 2002 Blick USA, Inc.
(Screen) Case
————
Case (Screen)
1
————
Case (Screen)
2
————
2
3
————
3
4
————
7
5
————
8
7
————
5
8
————
1
20
————
4
22
————
9
Appendix D - Cable Descriptions.
All the cables below are supplied by PAC Portico labeled and identified. However, a brief description is
included below for each cable.
6.7.1 Mains Supply
One mains lead is supplied with a molded plug and 5ft/1.5m of cable. A standard molded IEC socket
connects to the rear of the power supply unit.
6.7.2 Power Supply to CNC
One lead with 6.6ft/2m of cable is used to connect the power supply to the CNC. A male 9-pin D-type
connector fits to the power supply, a female 9-pin D-type connector fits to the CNC.
6.7.3 CNC to PC
Two cables are supplied, both 6.6ft/2m long with a female 9-pin connector at one end to connect to the
CNC host PC port. One cable has a female 9-pin D-type connector, the other a female 25-pin D-type
connector at the other end. You only need to use the cable that connects to the appropriate serial (COM:)
port on your PC.
6.7.4 Six Wire Bus
A short length of cable is supplied with a male 9-pin D-type connector at one end, the other end is flying
leads.