User Manual

15162 Ver 2.8 DRAFT E Central Network Controller Installation Guide
Page 36 © 2002 Blick USA, Inc.
(Screen) Case
————
Case (Screen)
1
————
Case (Screen)
2
————
2
3
————
3
4
————
7
5
————
8
7
————
5
8
————
1
20
————
4
22
————
9
Appendix D - Cable Descriptions.
6.14 Door Controller Software
Please note that when using a MKII CNC the software in the door controllers must be as follows:
6.14.1 PAC Portico 1100 and PAC Portico 2100
• Version 3.15 or later
6.14.2 PAC Portico 2200/1200 Series
• Version 1.08 or later.
Failure to ensure this could result in corrupt and incorrect transactions being reported and changes
made to the PC administration system not updating the information stored in the door controllers
correctly.
PAC Portico strongly recommends that to obtain maximum benefit from the improved features of the MKII
CNC, that all door controllers installed on the system are upgraded to PAC 1100, 2100 1200 or PAC 2200
Series Door Controllers with the firmware versions listed above.
6.15 Mean Time Between Failures
MTBF >100,000 hours