Manualshelf

User Manual

ManualsBrandsPAC International ManualsElectronicsAdmin panel with low range proximity reader
11121314151617181920
15263 Ver 2.1 DRAFT E PAC Portico 2200/1200 Series Installation Guide
Page 20 © 2003 Blick USA, Inc.
one for the alarm monitoring system for the same door.
The relays 5 to 8 only act as shunting relays when the corresponding door channel is assigned to an
alarm area. The following table illustrates the different actions of relays 5 to 8:
Relay Non-Alarm Panel Behavior Alarm Panel Behavior
5 Door 1 not assigned to an alarm area:
Responds to any door forced open or
tampered with.
Door 1 assigned to an alarm area:
Responds to contacts on door-1 opening
/ closing.
6 Door 2 not assigned to an alarm area:
Responds to time profile-1 going
active/inactive
Door 2 assigned to an alarm area:
Responds to contacts on door-2 opening
/ closing.
7 Door 3 not assigned to an alarm area:
Responds to any door left open after a
valid access by a user.
Door 3 assigned to an alarm area:
Responds to contacts on door-3 opening
/ closing.
8 Door 4 not assigned to an alarm area:
Responds to door controller case
being opened – assuming a micro-
switch has been fitted.
Door- assigned to an alarm area:
Responds to contacts on door-4 opening
/ closing.
By default, the shunting relay follows the state of the door contact. Optionally, the shunting relay can be
programmed to not trigger when a user accesses a building using a key. This allows personnel to enter
the building without an entry delay and subsequently disarm the alarm panel using its own keypad.
1.4.4 TCP/IP Interface
A TCP/IP interface unit can be fitted to the door controller that allows the serial port to be connected to a
PC across an existing Ethernet network. This interface will require some configuration before it can be
used (e.g. it will require a TCP/IP address).
The PAC Portico 2200IP Series have the TCP/IP interface built into the controller.
Configuration of the TCP/IP interface is performed using standard tools available with Microsoft
Windows®, such as Internet Explorer or Telnet.
Information on how to configure a door controller is contained on the PAC Prism CD.