User Manual

PAC Portico 2200/1200 Series Installation Guide 15263 Ver 2.1 DRAFT E

Figure 16 Metal Enclosure Option 2

5.1.2 Front Panel

The front panel is secured by two tabs that fit into slots in the power supply on the left-hand side of the

baseplate and by two spring clips on the right-hand side that attach to the baseplate. The ribbon

connector should be plugged into the socket on the circuit board at the top right of the board.

Note

When installing door controllers, be sure to check the lock output voltage before fitting the door

controller in the enclosure. Check the switch, visible through the top of the power supply housing, is

set for either 12V dc (factory setting) or 24V dc.

The door controller fits in the metal enclosure using two slots that fit over tabs on the back of the

enclosure. You should ease the tabs on the enclosure forward slightly to make locating the door controller

easier. The baseplate should then be secured using the single tab at the bottom of the baseplate using

the self-tapping screw supplied.