User Manual

PAC Portico PIN Reader Installation Guide 15826 Ver 1.8

DRAFT C

Surface Mounted

The reader is designed to be surface mounted onto a flat surface using the two holes provided,

therefore not requiring the installation of a back box. The readers performance is unaffected by

the material of the mounting surface. Ensure the surface is as even as possible to provide

maximum protection against the reader being levered from the wall.

The connecting cable can be taken via the hole provided on the lower section of the reader

housing and then surface mounted, preferably under the protection of a suitable conduit.

Alternatively, the cable could be taken directly from the terminals through a suitably prepared

hole in the mounting surface so as to be completely hidden from sight.

The holes are designed to accept size No.8 countersunk screws, preferably anti-tamper type, with

a recommended minimum length of 2in/50mm. This recommended length of course depends on

the surface type and construction.

The dimensions of the surface mounted reader are 8in/200mm x 4in/100mm x 1.3in/30mm.

Connections

Reader Connections

The connections for both readers are:

Color Signal Notes

Black 0V Negative supply

White SIG Reader signal

Brown VCA Valid code accept LED

Red +12V Positive supply