User's Manual

PAC 2200 Series and PAC 2100 Series

Programming Panel 170XX Ver 1.0

To use the Programming Panel:

1. Remove power from the door controller, not forgetting to disconnect any batteries as well.

2. Connect the flying lead from the panel as follows:

Into the socket at the top left of the door controller circuit board, just above the orange

power supply connector, for the PAC 2100 Series Controllers (Figure 1). The

connector is keyed and will only fit in the correct orientation.

Into the socket at the top right of the door controller circuit board for the PAC 2200 Series

Controllers (Figure 2). The connector is keyed and will only fit in the correct

orientation.

3. Power up the door controller again.

You will now be able to use the front panel in accordance with the instructions in the relevant

Installation and User Manuals.

Remove power from the door controller before disconnecting the panel.

Warning:

Take care not to allow the Programming Panel to drop, pulling the connector from the

door controller socket.

This device complies with part 15 of the FCC rules. Operation is subject to the following

two conditions (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

FCC ID OQL-PAC-FP