User's Manual

Page 4

Mounting the Reader

This reader should be mounted using the Vandal Resistant screws provided. You will need the

special screwdriver for these screws (Part no. 1950 - available separately).

Fixing the Reader

1. Ensure that the reader cable is

not

connected to the controller. Route the flying lead

behind the reader and connect it using the crimp connectors supplied. Wire the cable as

described in the Wiring section later in this manual.

2. If the connections are in a location that may be wet or damp, then protect the connectors

with a sealing compound, or use weatherproof crimps.

3. Using appropriate fixings, such as wall plugs, for the surface you are mounting it on, fix the

reader to as flat and even a surface as possible. This will reduce the possibility of it being

levered from the wall. Either use the Vandal Resistant screws provided, or other suitable

fixings. The LED should be at the top.

4. Apply a silicone sealant to any gaps behind the reader to protect against moisture if the

reader is mounted outside.