User Guide

ManualsBrandsPAC ManualsCar & Vehicle ElectronicsPAC RPK5-GM4101 Chevrolet Camaro Integrated Radio Replacement Kit 2010-15

Page 1 Page 1

PAC

| 866-931-8021 | support@pac-audio.com

www.pac-audio.com

Rev. 010317

Pacific Accessory Corporation

PAC is an AAMP power brand

RPK5-GM4101

Complete Radio Replacement Kit with

Integrated Climate Control Retention for

2010-2015 Chevrolet Camaro

Removing the factory radio from the vehicle

1.1 - Apply the parking brake. Move the transmission shift

assembly to the most rearward position possible. Use a

at bladed plastic trim tool and release the retainer tabs

securing the front oor console front cover to the console

assembly. Lift the cover (1) up and rearward making sure that

the accessory power receptacle and the electronic traction

control switch clears the transmission shift assembly. It may be

necessary to pop them loose from the underside to achieve

clearance. Disconnect the electrical connections.

1.2 - Remove the 2 x 7mm bolts (1) securing the radio

control assembly (2) into the dash. Then use a at-

bladed plastic trim tool in order to release the retainer

clips securing the radio control assembly (2) to the

instrument panel. Disconnect the electrical connections.

Parts List

The RPK5-GM4101 includes everything you need for a professional installation of an aftermarket radio in your Camaro.

This kit contains:

1. Dash Kit

• (x1) PAC HVAC Control Panel (Transfer of the factory HVAC knobs is required. See instructions below)

• (x1) Support Bracket Spacer kit (needed in vehicles equipped with the factory MyLink radio)

• (x2) Radio Mounting Brackets (One left and one right)

• (x1) Pocket (For single din applications)

• (x8) Radio Mounting Screws

2. RP5-GM4101 (Camaro specic radio replacement module)

3. Camaro specic antenna adapter (BAA-DIN22).

4. Rear camera retention cable for vehicles equipped with the MyLink system.

5. USB retention cable. This cable is compatible with vehicles equipped with the MyLink radios and vehicles equipped with the

standard non-touchscreen radios. It will require that the cable be ran to the back of the center console.

6. AUX retention cable for 2010-2012 vehicles equipped with the standard non-touchscreen radios also equipped with a USB port.

Overview

The RPK5-GM4101 is a complete radio replacement kit with integrated climate control retention for the 2010-2015 Chevrolet

Camaro. This kit utilizes the factory HVAC control knobs for a more factory look and experience. To add to the factory look

and experience the exterior temperature display is retained by a small OLED display at the top of the kit retaining this valuable

vehicle feature. This kit also includes all of the modules and cables needed to retain all of the important features of the factory

system such as OnStar, factory warning chimes, factory Bluetooth, steering wheel mounted radio controls, factory reverse

camera, factory amplier (if equipped), AM/FM reception, factory AUX jack (if equipped) and the factory USB port (if equipped).

Table of Contents: Page:

1. Factory Radio Removal ------------------------------------------------------ 1-2

2. Disassembly of the factory HVAC control module --------------------- 2-3

3. Assembly of the PAC HVAC control module ---------------------------- 3-4

4. RP5-GM4101 Instructions --------------------------------------------------- 4-6

5. AUX & USB Cable Installation ------------------------------------------------ 7

6. Temperature Display Settings ------------------------------------------------- 7

7. Sub-Dash Preparation ----------------------------------------------------------- 7

8. Kit Assembly Instructions ------------------------------------------------------- 8

9. Installation of the PAC HVAC control module --------------------------- 8-9

Summary of content (9 pages)

PAGE 1
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro Parts List The RPK5-GM4101 includes everything you need for a professional installation of an aftermarket radio in your Camaro. This kit contains: 1. Dash Kit • (x1) PAC HVAC Control Panel (Transfer of the factory HVAC knobs is required.
PAGE 2
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro Removing the factory radio from the vehicle (cont.) 1.3 - Remove the 4 x 7mm bolts (1) securing the radio (2) into the dash. Slide the radio (2) to the rear and disconnect all electrical connections. You can set the radio aside as it will not be used further.
PAGE 3
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro Disassembly of the factory radio control assembly (cont.) 2.7 - Remove the 12 Phillips head screws shown below. 2.8 - Be sure to keep the screws separated as they will be used during the assembly stage later. 2.10 - Look inside the opening where the knobs were removed. Remove the 2 Phillips screws shown below. Do this for both openings. 2.
PAGE 4
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro Assembly of the PAC HVAC control assembly (cont.) 3.3 - Position the knobs in the proper opening so that the buttons are straight and insert them into the opening. With VERY LITTLE force rotate them slightly left and right while pushing them towards the PCB. Once the alignment tabs are lined up they should click and lock into place.
PAGE 5
RPK5-GM4101 x3 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro RP5-GM4101 Illustration / Schematic SWC Connection AUX AUDIO Wiring Vehicle Connections SWC Connection Aftermarket Radio Connections CAMERA See above chart for different radio type connections RP5-GM4101 Installation Steps 9 01 SET RADIO SELECT SWITCH 456 23 Alpine JVC Kenwood Clarion / Nakamichi Pioneer/Other Sony Fusion 1 2 3 4 7 8 9 78 Other = Advent, BOYO,
PAGE 6
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro RP5-GM4101 Optional Steering Wheel Control Programming If you wish to re-assign the SWC functions or utilize short press long press dual command functionality, the interface must be programmed in the specific order shown in the chart below.
PAGE 7
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro USB and AUX cable Installation 1. Use a flat bladed plastic trim tool and release the retainer clips securing the console’s (1) right & (2) left side covers to the front floor console assembly. 2. Move the front seats to the forward most position. 3. Remove the 4 Phillips head bolts (3) securing the consoles rear cover (4) to the front floor console. 4.
PAGE 8
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro Kit Assembly Instructions (Double DIN) Double DIN Mount Applications 1. Remove the Shaded tab from the back edge of each left and right mounting bracket (right side not shown). FIG 2 2. Attach the left and right side brackets to an ISO mountable radio using screws provided with radio when possible or hardware included with kit. FIG 3 3. Insert kit and radio into dash.
PAGE 9
RPK5-GM4101 Complete Radio Replacement Kit with Integrated Climate Control Retention for 2010-2015 Chevrolet Camaro PAC HVAC Control Panel Testing and Verification 1. 2. 3. 4. Turn the ignition on. The LCD at the top of the kit should come on and display the temperature. Verify functionality of the lock, unlock and hazard buttons. Verify functionality of the rotary dials and all of the push buttons on each of HVAC knobs.