Owner's Manual
SWI-ADAPT
Introduction and Features
Two-wire SWC adapter for
PAC
products
featuring a wired 3.5mm SWC connector
The SWI-ADAPT is used in conjunction wi
th
many
PAC
steering wheel control interfaces to allow for connection to most
rad
ios t
ha
t requi
re
2 steering wheel control input wires (usually labeled
as
Key 1 and Key 2, or SW 1 and SW 2
).
Note: The SWI-ADAPT
ca
nnot be used without
an
addtitional PAC steering wheel control interface. Use the PAC-AUDIO
website (https://pac-audio.com) for assistance
in
selecting the correct steering wheel control interface for your application.
Installation
1. Install the
PAC
stee
ri
ng
wheel control interface to the vehicle following the instructions provid
ed
with the interface that
is
being used as if it
is
being installed to a Pioneer radio.
2. Connect the 3.5 mm jack steeri
ng
wheel output connector from the
PAC
steering wheel control interface into the 3.5 mm
jack input
on
the SWI-ADAPT. The Blue / Yellow wire from the
PAC
steering wheel control interface is not used.
3.
For Panasonic radios only - Cut the Light Green wire
in
half approximately half way between the connector, and
where it connects into the Black wire
in
the SWI-ADAPT harness, and insulate the
en
ds
of
the wires. For all radios
besides Panasonic, leave the Light Green wire intac
t.
4.
Wi
re the SWI-ADAPT power, ground and steering wheel control output wires as shown below:
Wire Color
Connection
Red
A
cce
s
so
ry
12 volts
=
Top View
Co
nn
ect
3.5
mm
jack
...
SWI
-
ADAPT
fromPACSWI
Int
erface
Bl
ac
k
Ground
I
Cut
Here
for
.,,
"
=
Brown
R
adio
's
SW
1
or
K
ey
1
Wi
re
Panason
ic ONLY
White
Radio's
SW
2
or
Key
2
Wire
Side View
...
Con
nect 3.5 mm jack
from
PA
C
SWI
SWI
-
ADAPT
Interface
Light
Gr
ee
n
O
nly
used
for
P
anaso
nic R
ad
i
os
(S
ee
No
te 3 A
bo
v
e)
D
...
LED
Ope
n
ing
Additional Info
1. The LED should illuminate red when the ignition is
on
, and should flash when steering wheel control buttons are being
pressed. If the LED is not
red
when the ignition
is
on
, check your Red wire and Black wire connections. If the LED is not
flashing when pressing steering wheel control buttons, check your 3.5 mm jack connection from the
PAC
SWI interface
to
the SWI-ADAPT, and make sure the PAC SWI interface was set to operate a Pioneer radio.
2. Enter the radio's steering wheel control settings menu
and
program the steering wheel controls to the radio. Consult the
radio's owner's manual for detailed radio programming instructions.
© 2018 AAMP Global. All rights reserved. PAC
ts
a Power Brand
of
AAMP Global.
PAC-audio com
Rev: 1
Date:070518