Manual

ManualsBrandsPace-Edwards ManualsFor the carSWITCHBLADE Chevy

CHEVROLET INSTALLATION INSTRUCTIONS

(800) 338-3697

www.paceedwards.com

Pace Edwards Company

2400 Commercial Blvd.

Centralia WA 98531

Tools Required for Assembly .......................................2

Before You Start ...........................................................2

Drain Hole Locations .....................................................2

STEP 1: Remove From Packaging, and

Hardware and Packaging Contents ..............................2

STEP 2: Positioning Canister ......................................3

STEP 3: Installing Rails ...............................................3

STEP 4: Installing Clamps............................................3

STEP 5: Attaching the Pull Strap..................................4

STEP 6: Lubricating & Placing Sweep Seals ..............5

STEP 7: Installing Drain Tubes.....................................5

STEP 8: Install Top Cover & Velcro .............................5

Operating Instructions ...................................................6

Helpful Maintenance Hints ...........................................6

Warranty Statement.......................................................7

Part #: SW_CHEVY_INSTRUCTIONS_1310

RETRACTABLE TRUCK BED COVERS

TABLE OF CONTENTS

(CHEVY1)

Summary of content (8 pages)

PAGE 1
RETRACTABLE TRUCK BED COVERS CHEVROLET INSTALLATION INSTRUCTIONS TABLE OF CONTENTS (800) 338-3697 www.paceedwards.com Pace Edwards Company 2400 Commercial Blvd. Centralia WA 98531 (CHEVY1) Tools Required for Assembly .......................................2 Before You Start ...........................................................2 Drain Hole Locations .....................................................2 STEP 1: Remove From Packaging, and Hardware and Packaging Contents ............................
PAGE 2
TOOLS REQUIRED FOR ASSEMBLY: Tape measure Side Cut or Needle Nose Pliers 7/16” wrench or socket Utility Knife #2 Phillips screwdriver Note: There should be no drilling into the truck body needed on most standard or full-size trucks . BEFORE YOU START: Read the instructions carefully before you start. If you have questions regarding the installation please visit our website www.paceedwards.com or call our Technical Support Line at (800) 338-3697.
PAGE 3
STEP 2: POSITIONING CANISTER Use the Pull Strap and one canister flange to lift and steady the unit. Wrap the Pull Strap around the center of the canister a couple times and double it up in your hand. Place the Canister in truck bed just behind the cab and center it from side to side. Ensuring that the canister is centered in the bed will help assemble the rails to canister in the next step.
PAGE 4
STEP 4: INSTALLING CLAMPS Secure the rails to the truck bed by installing two clamp assemblies per rail. Slide the Clamp Grip onto the Rail at the Clamp Relief and then slide it towards the Rail Bracket and Shim (Fig 4E and 4F). Then assemble the rest of the clamp parts as shown below (Fig 4C and 4D). Be sure to use the long grip at the canister end (Fig 4D) of the rails and the short grip at the tailgate end (Fig 4C).
PAGE 5
STEP 6: LUBRICATING & PLACING THE SWEEP SEALS Locate the sweep seals (rubber weather strips) on the rails. Open the provided 303 brand protectant sponge pack (find it adhered to the underside of the top cover) and wipe the underside of the sweep seal and the top of the wear strip. RAIL SWEEP SEAL Extend the cover to the tailgate. Use an Allen wrench if needed to carefully draw out the sweep seal (seal should be angled outwards toward the cover – not rolled in toward the bed rail). (Fig.
PAGE 6
OPERATING INSTRUCTIONS 1. To open the cover, open your tailgate and squeeze (pinch) together the Handle Tabs in the center on the underside of the cover. This retracts the latches and the cover is free to roll open into the canister. 2. To close the cover, pull on the strap to draw it back toward the tailgate. When it is within easy reach, grasp the handle by the hand grip and pull the cover to the latching position against the tailgate. Handle Tabs 3.
PAGE 7
C O N G R AT U L AT I O N S ! On your purchase of a Pace Edwards Retractable Truck Bed Cover. We are confident that you will get many years of trouble free service from this accessory to your truck. Please take a moment to fill out the warranty registration form to activate warranty coverage of your truck bed cover. PACE EDWARDS PRODUCT WARRANTY PACE EDWARDS (hereinafter referred to as the MFG.
PAGE 8
2400 Commercial Blvd, Centralia, WA 98531 USA (360) 736-9991 (main) (360) 736-9992 (fax) (800) 338-3697 (toll-free) www.paceedwards.