Operation Manual

21
About User Settings
Your installer should have made the correct settings to make sure your set-top is compatible with
your HDTV or TV. However you may wish to changes some settings, for example if you purchase a
new HDTV. You can make the following settings:
• TV Aspect Ratio (the screen’s width-to-height ratio, or shape);
• TV Display Capability (screen resolution);
• Auto Pillarbox;
• Closed Captions;
• Front Panel Settings.
You can also reset the user settings to the factory defaults.
You use the L, R, U, D and select buttons on either the front panel or the remote control to make
the settings. You check and change the settings by looking at your set-top’s front panel. You can also
look at the on-screen menus, although please note, in some circumstances these may not be visible.
Putting your set-top into “user settings mode”
1. Make sure that your set-top is switched on..
2. Press the power button on your set-top, then, within 1 second, press the
menu button
The front panel displays “ASPt” as shown far right. Depending on the set-up, you
may also see the User Settings menu, shown right, on the TV screen.
3. When you have finished making changes (see pages 22 to 30), press the power
button to remove the User Settings menu and return to normal viewing.
USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
Restore Defaults
power button.
menu button front-panel display
MAKING USER SETTINGS