Owner's Manual

Household circuit breaker Reset the circuit breaker.
is off
Treadmill circuit breaker Reset treadmill circuit breaker
has been tripped (located next to power cord
on front of treadmill see figure 8, page 14).
If at any point prior to, during, or after your workout the treadmill does not function properly and displays an error message, make a note of the error
message and the conditions under which it occurred (i.e. speed, elevation, etc..). First you should run the treadmill again to see if the error message
occurs again under the same conditions. If it occurs again call the dealer where you purchased the treadmill and explain the problem so he can
arrange to service your treadmill.
Interference
1. Reorient or relocate the antenna for the device that is receiving the interference.
2. Increase the distance between the device and the treadmill.
3. Confirm that the device is not plugged into an outlet on the same circuit as the treadmill.
Specifications
Motor - 2.5 HP continuous duty DC @ 120 VAC/60 Hz., 18.8 Amps DC
Speed Range - .7 to 11.0 M.P.H. (.1 M.P.H. increments)
Elevation Range - 0 to 15% grade (.5% increments)
Operating Temperature Range - 50° to 100° F
Maximum Permitted Weight - 300 lbs.
© Aerobics, Inc. 1995
PaceMaster is a registered trademark of Aerobics Inc.
18