Manual

Enclosure Construction: Weather-resistant, anodized alu-

minum enclosure with removable end caps to provide wiring

and programming access; end caps secured with screws.

Shipping Weight: 3.0 Lbs. approximate.

Warranty: “Two Years Warranty”.

Output Data: Data 0 and Data 1 standard Wiegand

electrical and protocol interface.

Operating Environment: -22°F to +155°F.

Mount: Inside the AeGIS 9000 Series or Outside.

INTRODUCTION

Pach and Company thanks and conratulates you on the purchase of

your AeGIS Wiegand Radio Reader (AWRR) and transmitter (AWRT).

The AWRR is designed to interface with AeGIS 9000 Series. The

AWRR will be installed inside the AeGIS 9000 Series if order at the

same time at no extra cost for installtion. The antenna will be mounted

on top of the system.

SPECIFICATIONS

Power Input: 5.0 - 24 VDC Regulated (5 VDC is supplied by the

AeGIS 9000 Series).

Current Consumption: 30 mA operating.

Radio Frequency:

318 Mhz

LO Reradiation: 200 microVolt/meter @ 3 meters (maximum)

Data Format: MegaCode

Sensitivity: -100dBm minimum

Desensitivity: 20 dB manual attenuation at the antenna input

Antenna: 9-1/2 in whip antenna with F-connector (supplied).

Bandwidth: 300 Khz

Image Rejection: 40 dB.

INSTALLATION

Figure 1

PAGE 1
INTRODUCTION Pach and Company thanks and conratulates you on the purchase of your AeGIS Wiegand Radio Reader (AWRR) and transmitter (AWRT). The AWRR is designed to interface with AeGIS 9000 Series. The AWRR will be installed inside the AeGIS 9000 Series if order at the same time at no extra cost for installtion. The antenna will be mounted on top of the system. SPECIFICATIONS Power Input: 5.0 - 24 VDC Regulated (5 VDC is supplied by the AeGIS 9000 Series). Current Consumption: 30 mA operating.
PAGE 2
Step 1 Set JP1 to 5VDC if the AWRR is connected to the AeGIS 9000 Series (see fig. 1). If the AWRR purchased as a package with the AeGIS 9000 Series, the systems are prewired from the manufacturer. Step 2 Turn the power OFF on the AeGIS 9000 Series. Step 3 Connect the wires as shown on fig.1. Step 4 Turn the AeGIS 9000 power ON. Step 5 The Red LED will turn ON then the Green LED will flicker and the Red LED will turn OFF. Step 6 Install the antenna on top of the AeGIS 9000 Series.
PAGE 3
Step 3 It is not necessary to set the DIP SWITCH B and D. PROGRAM AND TEST THE SYSTEM Step 1 With power applied to the receiver, press and release the program button, see fig.1. Step 2 Test the transmitters from various locations to determine the radio range. Step 3 Adjust the receiver internal radio range knob to limit radio reception if required (clockwise to increase, counter clockwise to decrease) Step 4 Reception pattern will vary depending on antenna used and surrounding structures.