Installation Guide

1 Apply Plumbers Tape
Apply plumbers tape, also known as thread seal tape, to the outlet side of the
shower arm in a clockwise direction.
2 Remove Flow Restrictor (Optional)
If you wish to have a stronger flow you may remove the rubber flow restrictor
found in the back end of the shower head.
3 Attach Shower Head
Thread showerhead onto shower arm by turning it in a clockwise direction. Tighten
with an adjustable wrench. After installing, turn on water supply to check for leaks.
MAINTENANCE AND CLEANING
Cleaning Tips: The finish on your shower head is designed to retain its beautiful
sheen for years. To maintain the original look of the finish, a little care and caution
should be used. We recommend the use of mild soap and water to clean the shower
head.
THE USE OF ABRASIVE CLEANERS MAY SCRATCH THE FINISH OR
CAUSE OTHER DAMAGE.
RECOMMENDED TOOLS AND MATERIALS
¨ Adjustable Wrench
¨ Plumbers Tape (Thread Seal Tape)
BEFORE YOU BEGIN
There are a variety of things to do before installing any new plumbing system into
your home or residence. Before you begin work make sure you:
¨ Shut off the main water supply
¨ Cover your drain to prevent loss of parts
¨ Observed any local plumbing codes
¨ Inspect fixture for damage - Replace as necessary
Pacific Bay reserves the right to make any revisions in the design of products
without notice.