Owner's Manual

12 13
Baery Replacement and Disposal
The baery will eventually lose the ability to hold a charge.
Depending on the amount of use, and varying condions, the
baery should operate for one to three years. Follow these steps
to replace and dispose the baery.
Important! Recycle the dead baery responsibly. The baery
contains lead acid (electrolyte) and must be disposed of properly
and legally. It is illegal in most areas to incinerate lead acid
baeries or dispose of them in landlls. Take it to a federal or
state-approved lead acid baery recycler, such as an authorized
service center or your local automove baery retailer. Do not
throw the baery away with your regular household trash!
Maintenance
Service
The ride-on toy should be checked for damage, missing or badly
worn parts before each use.
• Check the ghtness of the fasteners before each use.
• Check the ghtness of the wheels before each use.
• Ensure the baery is securely in place before each use.
• Store the ride-on toy indoors or cover it with a tarp to protect it
from the wet weather. Keep it away from sources of heat, such as
stoves and heaters.
• Do not leave the vehicle in the sun for long periods of me or
fading may occur. Store in shade or cover with tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap and water.
• Clean the vehicle with a so, dry cloth. To restore shine to plasc
parts, use a non-wax furniture polish. Do not use car wax,
abrasive cleaners or wash the vehicle with soap and water. Water
will damage the motor, electrical system and baery.
Do not return this product to the place of purchase. If your ride-on
toy needs service, repairs or replacement parts, call:
Pacic Cycle Consumer Relaons
Hours: 8:00 am – 5:00 pm (CST) Monday - Friday
Phone: [phone]
Email: [e-mail]
For a complete list of replacement parts, please contact
Pacic Cycle Consumer Relaons. To order parts, please have
the model and serial number available, which can be found
underneath the seat on the baery cover.
FCC Statement
Any changes or modicaons to this unit not expressly approved by
the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protecon
against harmful interference in a residenal installaon. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instrucons,
may cause harmful interference to radio communicaons.
However, there is no guarantee that interference will not occur in
a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be
determined by turning the equipment o and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separaon between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This ride-on toy contains a sealed
lead acid NON SPILLABLE BATTERY.
This baery must be recycled.
• DO NOT mix old and new baeries.
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) baeries.
• Non-rechargeable baeries are not to be recharged. Baeries are to be inserted with the correct polarity. Exhausted baeries are to
be removed from the toy. The supply terminals are not to be short-circuited. Rechargeable baeries are only to be charged under
adult supervision.
• Rechargeable baeries are to be removed from the toy before being charged.
Remote Control Use and Funcons
WARNING
Pairing the remote control to the ride-onInsert the baeries
Press the le buon to
turn le.
LED Indicator lights
Frequency buon
Reverse buon
Forward buon
❶ Press the frequency buon for 2-4 seconds unl the LED on
the remote control ash.
❷ Press the power buon on the car. The baery indicator
lights will ash through a sequence.
Note: If the battery indicator lights on the car do not go through
a lighting sequence, the remote control is not paired.
Repeat steps 1 - 2.
❶ Remove the small screw from the baery compartment cover.
❷ Insert two AAA-size baeries into the baery compartment
as shown.
❸ Replace the baery compartment cover and fasten with the
small screw you removed in step one.
❷
❸
❶
❶
❷
Emergency stop buon
Press the right buon to
turn right.