PACKARD BELL COMPASSEO USER'S GUIDE
Notices & Disclaimers Copyright Notice Packard Bell Compasseo User's Guide. Copyright © 2006 Packard Bell B.V. All Rights Reserved. No part of this manual may be reproduced or transmitted, in any form or by any means, whether electronic, chemical, manual or otherwise, including but not limited to photocopying, recording, or information storage and retrieval systems, for any purpose without prior written permission of Packard Bell B.V.
Product Disposal The Waste Electrical and Electronic Equipment (WEEE) Directive requires that used electrical and electronic products must be disposed of separately from normal household waste in order to promote reuse, recycling, other forms of recovery and to reduce the quantity of waste to be eliminated with a view to reducing landfill. This concerns your computer and all its accessories, such as a keyboard, mouse, remote control, speakers, etc.
Table of Contents Chapter 1 - Introducing the Packard Bell Compasseo...................................................... 5 1.1 Contents of the box ........................................................................................................... 5 1.2 Features ............................................................................................................................ 5 1.3 Controls ....................................................................................................
Chapter 1 - Introducing the Packard Bell Compasseo 1.1 Contents of the box • • • • • • • Compasseo 12V cigarette lighter adapter Car holder kit USB cable SD/MMC card (with country map) Companion CD/DVD (documentation & software) Quick Start Guide 1.2 Features • • • • • • • • • • • • Plug and drive GPS device 3.
Power Switch External GPS antenna connector (MMCX type) Battery charging LED Touch screen Slide to power on or off the device. If your car has a heat reflective/thermal windscreen, you may need to use an external antenna to get better GPS reception. 11 Indicates the status of battery. Read status and information on the screen. Tap the screen to enter information and navigate through the applications. Insert an SD/MMC card to read maps, music, photos. SD/MMC card slot Adjust the volume.
Chapter 2 - Getting Started 2.1 Powering ON/OFF Simply slide the Power Switch up or down to power on or off the Packard Bell Compasseo. 2.2 Connecting to your computer You will need to connect to your computer to get the latest maps, points of interest or software updates (Internet connection required). Note: you will only need to go through the installation process once. 1. Connect the small end of the supplied USB cable to your Compasseo and the other to one of your computer's USB ports. 2.
2.3 Disconnecting from your Computer 1. 2. 3. 4. Click on the Safely Remove Hardware icon in the Notification area (next to the clock). Click on Safely remove USB Mass Storage Device. Wait until a Safe to Remove Hardware message is displayed. Remove the device. 2.4 Charging the Battery You are recommended to fully charge the battery each time the device is completely discharged. This will ensure maximum performance. Avoid frequent full discharges, because this puts additional strain on the battery.
z Charging with the cigarette lighter adapter: You can plug in the cigarette lighter adapter to charge the Compasseo in your car. Note: It may take up to 5 hours to fully charge the device. z Charging with the AC adapter (optional): Connect the AC adapter cable to the USB connector on your device. The device will automatically charge. Note: It may take up to 2.5 hours to fully charge the device.
Chapter 3 - Troubleshooting & Upgrading the Compasseo 3.1 Resetting the device Reset Button: Should the Compasseo freeze or become unstable, insert a straightened paper clip into the Reset button located on back of the device. The device will then restart. Hard Reset: Use the battery lock switch to cut all power to the device. Note that this also resets the device's memory and restores the factory default settings of the device.
Chapter 4 - Installing the Packard Bell Compasseo in your car Setting up the device Please refer to the pictures on the following page and instructions below to set up your device correctly. 1. To assemble your car holder kit first attach the cradle to the suction-mount gooseneck. Ensure that the 'CLOSE' arrow points in the direction you attach the cradle. 2. Place the car holder kit in a suitable location on your windscreen and release the clip at the base of the gooseneck. 3.
Specifications Hardware Processor: Samsung S3C2410X02/A26 with internal clock speed 266MHz On Board Memory FLASH: 32MB for OS image and applications DRAM: 64MB Display LCD: 3.5” TFT-LCD Backlight: six levels of intensity (0, 20, 40, 60, 80 and 100% of the maximum level) Touch Panel: 300 DPI touch screen; Finger-tapping type Audio CODEC:16-bits stereo; 44.1KHz max sample rate. Earphone Jack: 3.5 mm stereo earphone jack Speaker Battery Battery Pack: 3.7 volt Lithium-Ion cell (non-removable), 1 100 mAh.
