User Manual

Packet Power™ Ethernet Gateway Version 3 Product Manual
Copyright 2014 © Packet Power, LLC.
2
Device Setup
 Connect the Gateway to a router (using a standard network cable) with network access using
the Ethernet port on the back of the Gateway.
 Connect the power supply provided or any 5 VDC source to the DC input of the Gateway.
The Gateway can be powered using PoE (Power over Ethernet) using a splitter and 5VDC
PoE source.
 Once energized the Gateway will indicate it’s firmware version, then device ID number (also
found on the top label of the Gateway) followed the IP address (may be blank if operating
DHCP mode); note that the IP address may take up to two minutes to display.
POWER UP DISPLAY SEQUENCE
FIRMWARE
VERSION
DEVICE ID
IP ADDRESS