Product Info

Dragon-C Manual

- 15 -

5.7.Label and compliance information

The outside of final products that contains this module device must display a label referring to

the enclosed module. This exterior label can use wording such as:”FCC ID:2AQV6DRAGON”,

Any similar wording that expresses the same meaning may be used.

5.8.Information on test modes and additional testing requirements

The Dragon-C module is based on CYW20706UA2KFFB4GT chip.Support standard Bluetooth HCI

UART commands. For the testing module on your product, user can refer to specification of the

Bluetooth system on how to configure and evaluate the module.

This specification can also be found on the official Bluetooth web site:

https://www.bluetooth.org/en-us/specification/adopted-specifications.

6.FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment. This device complies with part 15 of

the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause

harmful interference, and (2) This device must accept any interference received, including

interference that may cause undesired operation.

7.ISED Compliance Information

This device complies with Industry Canada’s applicable licence-exempt RSSs. Operation is subject

to the following two conditions: (1) This device may not cause interference; and (2) This device

must accept any interference, including interference that may cause undesired operation of the

device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio

exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) l’appareil ne

doit pas produire de brouillage; 2) l’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en compromettre le

fonctionnement.

8:OEM/Integrators Installation Manual

This module has been granted modular approval for mobile applications. OEM integrators for

host products may use the module in their final products without additional FCC / IC (Industry

Canada) certification if they meet the following conditions. Otherwise, additional FCC / IC

approvals must be obtained.

 The host product with the module installed must be evaluated for simultaneous

transmission requirements.

 The users manual for the host product must clearly indicate the operating requirements and

conditions that must be observed to ensure compliance with current FCC / IC RF exposure

guidelines.