Safety Instructions

PAJ GPS Finder 01 by PAJ GPS with Online-Tracking V.1.0 EN

Note: To activate you need the device ID. Please

make a note before installing your FINDER.

To do this, please go to

www.start.finder-portal.com

and follow the instructions.

1.5 Installation

Please proceed as follows when connecting the

Finder to your car battery. The following figure serves

as a guide.

1. Connect the PAJ GPS Finder to the cable harness

using the black plug-in function.

2. Connect the device to the battery. Connect the red

cable with the fuse to (+). Connect the black cable

to Minus (-).

Attention! The poles must never be reversed.

Note: When connected to the power supply, the

PAJ GPS Finder switches on immediately and the

LED lights emit a signal.

1.6 Turning on

After a successful activation you can switch on the

PAJ GPS FINDER.

By connecting the FINDER to the power supply, the

device has already been switched on.

For the initial startup of the PAJ GPS Finder

uncovered locations, such as the garden or the

terrace (i. e. not inside the home, the garage, the

cellar or the like) are recommended.

1.7 Use

Once the activation and switching on of the FINDER

has been successful, you can attach the FINDER to a

location of your choice and view the position of the

FINDER using a smartphone, tablet or PC. Please use

our app or go to the following website:

Battery

12-24V

Black

Red

Fuse