User Manual

Page 242 Maintaining Your Handheld
To be sure the antenna is raised to 180
°
, place the handheld face
down on a flat surface and flatten the antenna against the sur-
face.
4. Grasp the antenna close to the pivot point with your thumb and
index finger.
5. Using your thumb, firmly push the antenna out of the pivot point.
Note: After you remove the antenna, be careful not to change
the alignment of the pivot point.
To insert the new antenna:
1. Holding the antenna in the 180
°
position, insert the contact pin into
the center hole of the pivot point.
2. Align the transverse pin with the opening for it in the pivot point.
Push the antenna the rest of the way into the pivot point until you
feel the antenna snap into place.
3. Lower the antenna.
4. Put the AAA batteries back in.
5. If necessary, perform a HotSync operation to restore your data.
Contact pin
Pivot point
Transverse pin