Instruction Manual Part 15

Performing HotSync
®
Operations
148
If you’re not sure which option to use, keep the default setting: Always
available.
4. If you are using a serial cradle, click Local tab to display the settings for the
connection between your computer and the handheld cradle, and adjust the
following options as needed.
If you are using the USB cradle, you do not need to use the settings on the Local
tab for a direct HotSync operation.
5. Click the Modem tab to display the modem settings and adjust the options as
needed. See “Conducting a HotSync Operation Via Modem” later in this
chapter for more information.
6. If you are attached to a network, click the Network tab to display the network
settings and adjust the options as needed. See “Conducting a HotSync
Operation via a Network” later in this chapter for more information.
7. Click OK.
Available only
when Palm
Desktop software is
running
Starts HotSync Manager and monitors requests
automatically when you open Palm Desktop software.
Manual
Monitors requests only when you select HotSync Manager
from the Start menu.
Serial Port
Identifies the port that HotSync Manager uses to communicate
with the cradle. The Palm Desktop installation software
automatically detects the port to which you connected the
cradle. If necessary, you can change the port selection.
Your handheld cannot share this port with an internal modem
or other device.
Speed
Determines the speed at which data is transferred between
your handheld and Palm Desktop software. Try the As Fast As
Possible rate first, and adjust downward if you experience
problems. This setting allows Palm Desktop software and your
handheld to find and use the fastest speed.