User's Guide
Table Of Contents
- Getting to Know Your Treo™
- Turning Your Treo On and Off
- The Backlight, Display, and LED
- Charging the Battery
- Using the Keyboard
- Using Your Phone
- Getting to know the PhoneBook screen
- Making a call from the Speed Dial, Contacts or Call History views
- Making a call from the Dial Pad view
- Receiving calls
- Working with active calls
- Adjusting call volume
- Ending a call
- Adding a contact
- Viewing or changing contact information
- Deleting a contact
- Defining speed dial buttons
- Using a headset
- Date Book Plus
- Blazer Web Browser
- SMS Messages
- Accessing Other Applications
- Preferences and Other Settings
- Synchronizing Data with Your Computer
- Beaming Information
- Resetting Your Communicator
- Using the Electronic User Guide
- Troubleshooting
- My communicator will not turn on.
- I have trouble synchronizing with my computer (performing a HotSync operation)
- I can’t open the electronic User Guide.
- When I turn on wireless mode, I get a message that my SIM card is missing.
- My Treo will not connect to the Internet using Blazer or my e-mail application
- FCC Statement
Page 30 Synchronizing Data with Your Computer
Upgrading from a Palm OS handheld
1. Synchronize your old handheld with your old desktop software.
Tip: For best results, review the detailed steps in the Upgrade Information section
in the electronic
User Guide
.
2. Under your Palm or Handspring folder, locate your User Name folder and store a copy
of it in a safe place.
3. Install your new desktop and synchronization software from your Handspring CD and
put it in the same location as your old desktop software.
Note: Installing the new desktop software is strongly recommended to ensure that
you have the latest synchronization software.
4. Synchronize your new Treo with your new desktop software, and select the user name
for your old handheld when prompted.
5. If any third party applications or data did not get installed, beam them from your old
handheld to your Treo.
6. After you upgrade you have two devices with the same user name. Since each device
must have a unique name, perform a hard reset (see page 33) on your old handheld to
remove the user name and avoid problems synchronizing with that device. The next
time you synchronize that device, be sure to assign it a new name.
Installing the desktop software
1. Insert the Handspring CD in the CD-ROM drive on your computer.
2. If you’re using a Macintosh, double-click the Handspring CD icon on the desktop, and
then double-click the Installer icon.
3. If the language selection screen appears, click the same language you selected on your
communicator. Choosing a different language may result in loss of data.
4. If the model selection screen appears, click the name of the product you purchased and
follow the onscreen instructions to continue the installation.
5. When the wireless data access screen appears, follow the onscreen instructions to
configure your Treo for wireless data communications.
When the set up process is done, the installation screen closes automatically.