Use and Care Manual

ASSEMBLY
Do not attempt assembly if parts are
missing. Use this manual to order repair
parts.
Getting to Know Your Dust Extractor
Refer to Figure 1.
Base Plate Layout Guide
Refer to Figures 2 and 14.
This is a brief guide to where the separate components should be
attached to the base plate (Ref. No. 3) (as viewed from above).
A. These holes are for fitting the 4 casters (Ref. No. 1).
B. These holes are for fitting the motor support bracket
(Ref. No 5).
C. These holes are for fitting the bracket of the motor/fan
assembly (Ref. No. 8).
D. These holes are for fitting the 3 collector supports
(Ref. No. 14).
Fitting the Casters
Refer to Figures 2, 3 and 14.
1. Locate the holes (Ref. A) for mounting the casters (Ref. No. 1)
onto the base plate (Ref. No. 3). There are 4 at each corner.
2. Line up the holes on the casters with those on the base plate.
3. Use the 4 x cross head screws, washers and nuts (Ref. Nos.
23, 16 and 19) to secure the 4 x casters.
NOTE:
The 2 x strengthening braces (Fig. 3) should be on the
bottom of the completed assembly.
Fitting the Motor Support Bracket
Refer to Figures 2, 4 and 14.
1. Locate the holes (Ref. B) for mounting the motor support
bracket (Ref. No. 5).
2. Line up the holes on the bracket with those located on the base
plate (Ref. No. 3).
3. Secure with 4 x M8 x 16 bolts and washers (Ref. Nos. 6
and 4.)
5
NORSE Operating Manual & Parts List 9686006
GETTING STARTED
SAFETY / SPECIFICATIONS
ASSEMBLY / INSTALLATION
OPERATION
TROUBLESHOOTING
MAINTENANCE / REPAIR
Filter Bag
Main
On-board
Hose
Motor
Main
ON/OFF
Switch
Double
Inlet
Adaptor
Collection
Bag
Figure 1 - Know your dust collector.
Figure 2 - Layout guide to main base plate assembly.
Figure 3 - Fitting casters to baseplate.
Figure 4 - Fitting motor support bracket to base plate.
9686006_oipm_En012_9643286.01 0318 03/07/18 Page 5