Use and Care Manual

6
GETTING STARTED
SAFETY / SPECIFICATIONS
ASSEMBLY / INSTALLATION
OPERATION
TROUBLESHOOTING
MAINTENANCE / REPAIR
NORSE Operating Manual & Parts List 9686006
ASSEMBLY
(
CONTINUED
)
Fitting the Motor/Fan Assembly
Refer to Figures 2, 5 and 14.
Due to the weight of the motor/fan
assembly, this operation should be
carried out by at least 2 persons to reduce the risk of injury.
1. Locate the holes (Ref. C) for mounting the motor/fan assembly
(Ref. No. 8) onto the base plate (Ref. No. 3).
2. Place the motor/fan assembly onto the base plate. Use the
motor support bracket (Ref. No. 5) to take the weight of the
motor.
3. Line up the holes on the motor/fan assembly with the holes on
the base plate, as well as the holes on the motor with the holes
on the motor support bracket.
4. Secure the fan/motor assembly to the base plate with 2 x M8 x
16 bolts and washers (Ref. No. 6 and 4).
5. Secure the motor to the motor support bracket with 4 x M8 x
25 bolts, 8 x washers (1 above and 1 below) and 4 x M8 nuts
No. 12, 4 and 2).
Fitting the Main Fan Assembly Outlet
Refer to Figures 6, 7 and 14.
1. Fit the main fan assembly outlet seal (Ref. No. 29) over the fan
assembly outlet, ensuring that the holes on the seal line up with
the holes on the outlet.
2. Fit the main fan assembly outlet (Ref. No. 30) over the seal.
3. Secure it in place with 6 x M6 x 20 bolts, 12 x washers (one
above and one below) and 6 x nuts (Ref. Nos. 15, 16 and 19).
Fitting the Collector Supports
Refer to Figures 2, 8 and 14.
1. Locate the holes (D) on the base plate (Ref. No. 3) where the
collector supports (Ref. No. 14) are to be fitted.
2. Line up the holes on the collector supports with those on the
base plate.
3. Secure the collector supports with 2 x M8 x 16 bolts and 2 x
washers (each) (Ref. Nos. 6 and 4).
NOTE:
Ensure that the supports are fitted with the bracket at the
top stepping inwards, this will allow for the collector assembly (Ref.
No. 33) to be fitted correctly. Refer to Figure 8.
Fitting the Collector Assembly
Refer to Figures 8 through 10 and 14.
1. Set the collector assembly (Ref. No. 33) inside the collector
supports (Ref. No. 14).
NOTE:
Ensure the inlet of the collector assembly faces towards the
motor and that the angled section inside the collector faces
upwards. Refer to Figure 8.
Figure 5 - Fitting motor/fan assembly.
Secure motor bracket
to base plate.
Secure motor/fan assembly
to motor bracket.
Figure 6 - Fan assembly outlet seal.
Fan Assembly
Outlet Seal
Figure 7 - Main fan assembly outlet.
Main Fan
Assembly
Outlet.
Figure 8 - Fitting collector supports.
Note: Support
brackets should
face inward.
Figure 9 - Fitting collector assembly.
Angled Section
Inlet
9686006_oipm_En012_9643286.01 0318 03/07/18 Page 6