Use and Care Manual

7
NORSE Operating Manual & Parts List 9686006
GETTING STARTED
SAFETY / SPECIFICATIONS
ASSEMBLY / INSTALLATION
OPERATION
TROUBLESHOOTING
MAINTENANCE / REPAIR
ASSEMBLY
(
CONTINUED
)
2. Line up the holes on the supports with those on the collector
assembly.
3. Secure the 2 side supports to the collector assembly with 2 x
M8 x 16 bolts and washers (each) (Ref. No. 6 and 4).
NOTE:
The fixing point of the 3rd support is also used to connect
the upper bag support (Ref. No. 13).
4. Line up the holes on the upper bag support with those on the
collector and collector support.
5. Secure with 2 x M8 x 16 bolts and washers.
NOTE:
The fixing point of the 3rd support is also used to connect
the upper bag support.
6. Line up the holes on the upper bag support with those on the
collector and collector support.
7. Secure with 2 x M8 x 16 bolts and washers.
Fitting the On-Board Hose
1. Slide the 2 x hose clamps (1 at each end) (Ref. No. 31) over
the main on-board hose (Ref. No. 32).
2. Slide one end of the hose over the main fan assembly outlet
(Ref. No. 30) and the other end over the inlet of the collector
assembly (Ref. No. 33).
3. Tighten both hose clamps to secure.
Fitting the Double Inlet Adaptor
Refer to Figures 11 through 13 and 14.
1. To fit the double inlet adaptor (Ref. No. 24), simply slide it over
the main inlet of the motor/fan assembly (Ref. No. 8).
2. Line up the securing hole on the double inlet adaptor with the
hole on the main inlet.
3. Secure with the screw provided.
INSTALLATION
Do not permit fingers to touch terminals
of plug when installing or removing the
plug to or from the outlet.
Do not connect to power source until
unit is completely assembled.
Power Source
• Motor is designed for operation on the voltage and frequency
specified on motor nameplate.
• Normal loads will be handled safely on voltages not more than
10% above or below the specified voltage.
• Running unit on voltages not within range may cause
overheating and motor burnout.
Figure 9 - Fitting collector assembly.
Upper Bag
Support
Collector
Support
Figure 10 - Fitting on-board hose.
Figure 11 - Main inlet.
Figure 11 - Slide double inlet adapter over main inlet.
Figure 12 - Secure with screw.
9686006_oipm_En012_9643286.01 0318 03/07/18 Page 7