Installation Guide

Notes During
Assembly
Use a soft platform below the
parts to avoid scratches and
damages.
Product dimensions can be
adjusted to your specific needs:
1.The wall- mounting profile (top
-back) can be adjusted from
260 to 305 cm (102.4 "to
120 ") above ground.
The
adjusting is done when
measuring and drilling (Step 9).
Please note the installation
recommendations' height
suggested in Diagram A.
It is
possible to fix the Patio
Cover back wall height at the
lowest point of 260 cm/102.4 ".
This method is optional if the
assembly conditions and exterior
walls do not allow to follow
the suggested installation as
appears in the manual.
Please note that the product
appearance may slightly change
as a result, however snow
load weight does not change.
2.
Poles distance from the wall
can be adjusted from 226 to
286 cm (89 "to 112.5 ") as
suggested in Diagram B1.
Poles distance from the side
edges can be adjusted from 0 to
54 cm (0 "to 21.3 ") as
suggested in Diagram B2.
The
adjusting is done after
assembly and before anchoring
(Step 27) by sliding poles and
profile 7040 +7041 at the
roof
profiles' channels.
3.
Wall mounting and distance
from the wall determine the
roof angle and the total depth
of the product (distance of
gutter from the wall). Higher wall
mounting and shorter
distance between wall and poles
increase the roof angle and
shorten the total depth as
suggested in Diagram C.
Í
n
Steps
Step 7,8: Please apply silicone
sealants to the inner and outer
edges of parts 7043 + 7042
as well as to the
middle of parts 7029 + 7039 in
order to prevent water from
seeping in.
Step 16: Please apply silicone
sealants above beam 7288 +
7290, in order to prevent water
from seeping in.
Step 18: Make sure that the
angle between the back wall
profile and the panel supporting
profiles is 90 degrees.
Assembly of the panels should
start from the middle of the
patio cover to each side
alternately.
Step 27: Please adjust the poles
(inside out and sideways) by
sliding them to their final
position prior to anchoring.
Make sure that the poles distance
from the Patio cover side
edge does not exceed 54
cm/21.3 ".
*Please note: Anchoring this
product to the ground is
essential to its stability and rigidity.
It is required to complete
this
stage in order for your
warranty to be valid. (Step 28)
*Tighten all screws when
completing assembly.
Note:
The wall anchoring kit
supplied with this product is suitable
only for concrete walls.
Other wall types need an
accordant wall fixation kit.
(Contact your supplier)
i
260 -305cm
102.4" -120"
0
B1
226 -286cm
89"- 112.5"
0 -54cm
0'- 21.3"
.
L
.
13°
t0
+ 17°
.
-
f
f
i
i
-
-