Replacement Part List

FOUNDATION
Base or foundation must be flattened, leveled
and prepped prior to installing the shed!
The shed must be built on a solid level surface
in order to perform properly. We recommend
using concrete or wood deck as base.
The shed cannot be built on grass or gravel.
**
We recommend checking for restrictions
or covenants for building sheds in your area. In
addition we advise you to check if you need to
sumbit any forms or if any permits are required
prior to building the shed.
Site Preparation!
Clear the surface of loose empediments
Level the ground surface
* See below 2 recommended options
A Concrete (drawing)
B Wood deck (drawing)
In order to allow easy access during assembly,
make sure you clear the surface around the shed's
assembly site.
Make sure you have at least 5 cm (2 in.) between
the shed's base and the edge of your foundation.
A Anchoring shed to concrete:
Secure the shed to the concrete slab using
suitable screws and plugs or masonry anchors.
(Screws and plugs or masonry anchors are not
supplied)
B Anchoring shed to wood deck:
Secure the shed to the wood deck using suitable
standard lag bolt screws or structural screws.
(Standard lag bolt screws or structural screws are
not supplied)
La base ou la fondation doivent etre aplaties,
nivelees et preparees avant !Installation du
hangar !
Le hangar doit etre construit sur une surface de
niveau solide afin de fonctionner correctement.
Nous recommandons !'utilisation de beton ou le
plancher en bois comme fondation.
Le hangar ne peut pas etre construit sur
l'herbe ou le gravier.
** Nous recommandons la verification des
restrictions ou les accords de construction
de hangars dans votre region. Nous vous
recommandons de verifier si vous avez besoin de
soumettre des formulaires ou si des permis sont
requis avant la construction du hangar.
La preparation du terrain !
Degagez la terrain des obstacles libres
Niveler la surface du terrain
* Voir deux options recommandees ci-dessous
A - Beton (dessin)
B - Plancher en bois (dessin)
Afin de permettre un acces facile pendant
('assemblage, assurez-vous de &gager la surface
autour du site de montage du hangar.
Assurez-vous d'avoir au moins 5 cm (2 po) entre
la base du hangar et le bord de votre fondation.
A Ancrage du hangar au beton :
Fixez le hangar a la dalle de beton a l'aide de
vis et de chevilles appropriees ou d'ancres de
maconnerie. (Les vis et les chevilles ou les ancres
de maconnerie ne sont pas fournis)
B L'ancrage du hangar au plancher en bois :
Fixez le hangar au plancher en bois avec des
vis a boulon standard ou de vis structurales
appropriees. (Les vis a boulon standard ou les vis
structurelles ne sont pas fournies)
Der Boden oder das Fundament mussen vor der
Montage des Schuppens planiert, nivelliert und
vorbereitet werden!
Der Schuppen muss auf einem festen, ebenen
Untergrund errichtet werden, um seine Funktion
einwandfrei leisten zu konnen. Wir empfehlen die
Verwendung von Beton oder eines Holzdecks als
Untergrund.
Der Schuppen kann nicht auf Gras oder Kies
aufgebaut werden.
** Wir empfehlen
die Prufung auf
Einschrankungen oder Verpflichtungen an
I hrem Wohnort hinsichtlich dem Erbau eines
Schuppen. Dal-Ober hinaus empfehlen wir Ihnen,
vor dem Bau des Schuppens zu prufen, ob Sie
irgendwelche Formulare ausfullen mussen oder ob
Genehmigungen erforderlich sind.
Baustellenvorbereitung!
Entfernen Sie die jegliche Hindernisse von der
Oberflache.
Bodenoberflache nivellieren
* Siehe unten zwei empfohlene Optionen
A Beton (Zeichnung)
B Holzdeck (Zeichnung)
Um einen leichten Zugang wahrend der Montage
zu ermoglichen, ist darauf zu achten, dass die
Oberflache um den Montageort des Schuppens
herum frei ist.
Stellen Sie sicher, dass Sie mindestens 5 cm (2
in.) zwischen dem Schuppenboden und dem Rand
Ihres Fundaments haben.
A Befestigung des Schuppen auf Beton:
Den Schuppen mit geeigneten Schrauben und
Dubeln oder Mauerdubeln an der Betonoberflache
befestigen. (Schrauben und Dube! oder
Mauerdubeln werden nicht mitgeliefert)
B Befestigung auf dem Holzdeck:
Befestigen Sie den Schuppen am Holzdeck mit
geeigneten handelsublichen Schrauben und Bolzen
oder Konstruktionsschrauben. (Diese Standard-
Schrauben, bzw. die Konstruktionsschrauben
werden nicht mitgeliefert)
iLa base o cimentaci6n debe estar aplanada,
nivelada y lista antes de instalar el cobertizo!
El cobertizo debe construirse sobre una
superficie sOlida y nivelada para funcionar
correctamente. Recomendamos usar una
plataforma de concreto o madera como base.
El cobertizo no se puede construir sobre
hierba o grava.
**
Recomendamos verificar restricciones u
ordenanzas para la construcci6n de cobertizos en
su area. Adernas, le aconsejamos que verifique si
necesita enviar algun formulario o si se requieren
permisos antes de construir el cobertizo.
iPreparacion del Sitio!
Despeje la superficie de obstaculos sueltos
Nivele la superficie del suelo
* Abajo, yea 2 opciones recomendadas
A Hormigan (Dibujo)
B Deck de madera (Dibujo)
In order to allow easy access during assembly,
make sure you clear the surface around the shed's
assembly site.
Make sure you have at least 5 cm (2 in.) between
the shed's base and the edge of your foundation.
A Anchoring shed to concrete:
Secure the shed to the concrete slab using suitable
screws and plugs or masonry anchors. (Screws and
plugs or masonry anchors are not supplied)
B Anchoring shed to wood deck:
Secure the shed to the wood deck using suitable
standard lag bolt screws or structural screws.
(Standard lag bolt screws or structural screws are
not supplied)