Use and Care Manual

IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
EN
18.12
Safety advice
• For safety purposes we strongly recommend the product to be assembled by at least two people.
• Be sure to check that there are no hidden pipes or cables in the wall before drilling.
• Some parts may have sharp edges. Please be careful when handling components. Always wear
gloves, eye protection, and long sleeves when assembling or performing any maintenance on
your product.
• Do not attempt to assemble the product in windy or wet conditions.
• Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
• Dispose of all plastic bags safely – keep them away from children’s reach.
• Keep children away from the assembly area.
• When using a stepladder or power tools, make sure that you are following the manufacturer’s
safety advice.
• Do not climb or stand on the roof.
• Do not hang or lay on the proles.
• Keep roof and gutters clear of snow, dirt & leaves.
• Heavy snow load on the roof can make it unsafe to stand below or nearby.
• If color was scratched during assembly it can be xed.
Cleaning instructions
• In order to clean the product, use a mild detergent solution and rinse with cold clean water.
• Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
• Clean the product once assembly is complete.
Before Assembly
• Choose your site carefully before beginning assembly.
• Consider the door’s opening (inside or outside).
• Sort the parts and check against the content parts list.
• Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do not
get lost.
• Please consult your local authorities if any permits are required prior to constructing the product.
Additional information
• Please apply silicone sealant if needed
• During assembly, use a soft surface below the parts to avoid scratches and damages.
• You are solely responsible for determining whether the handling, storage, assembly,
installation or use of this product is safe and appropriate in any location or for any
given application. The manufacturer is not responsible for any damages or injury to
you, any other person or any property resulting from the improper handling, storage,
installation, assembly or use of this product, or the failure to follow the manufacturer’s
written instructions regarding the handling, storage, installation, assembly and use of this
product. This product is intended for normal residential use only. Do not use this product
for any application that is not recommended in these instructions or building codes in
eect in location where this product will be used. Always take care and use appropriate
safety equipment (including eye protection) when assembling or installing this product.
• Please note: it is possible to extend the canopy, however once fully assembled it is
impossible to add the extension.
* Please tighten all screws when completing assembly.
Note: The wall anchoring kit supplied with this product is suitable for concrete or solid
brick walls. Other wall types need an accordant wall xation kit.