Use and Care Manual

IMPORTANT
Please read these instructions
carefully before you start to assemble this shed.
Please carry out the steps in the
order set out in these instructions.
Keep these instructions in a safe
place for future reference.
Tools & Equipment
Tool - (supplied)
,afetv
IRThis
shed must be placed
and fixed on a leveled surface to ensure its stability.
Make sure that screws and
anchors are compatible with surface type.
IRSome
parts have metal
edges. Please be careful when handling components.
RAlways
wear gloves, eye
protection, and long sleeves when assembling or
performing any
maintenance on your shed.
IRDo
not attempt assembly on
days with strong winds or low temperatures.
IRIf
using a stepladder or
power tools ensure that you follow the manufacturer's safety
advice.
IRDo
not stand on the roof.
RDo
not store hot items such
as recently used grills, blowtorches etc. in the shed.
IRHeavy
or sharp articles
should not be leaned against the wall panels.
IRTo
prevent suffocation, do
not allow children to play with packing materials.
IRShed
must be secured by
drilling through floor panels holes locations and inserting
suitable screws into ground
defore you start
Consult your local
authorities for any building limitations or permits required to
construct this garden shed.
Complete site preparation
before unpacking parts and beginning assembly.
It is highly recommended
to be assisted by a second person in some steps.
Sort the parts and check
against the contents parts list.
Please take safety
precautions during assembly.
During Assembly
N
When encountering the information icon,
please refer to the relevant
assembly step for additional comments and
assistance.
This icon indicates This icon
indicates that
that the installer should 11 the
installer should be
be inside the product. outside
the product.
Attention:
v When assembling the roof, it is important
to drill the screws at the top
end of the panel and to make sure that
screws penetrate through in
order to achieve maximum durability.
RtMake
sure to position the panel's bottom
end towards the shed floor
and that it is enclosing it.
RtAll
the extension module steps are
marked with a dashed outline,
should be performed during the shed's
assembly process.
Step 3: Refers only for the extension kit! The
extension kit contains a base
connector, either part # 8447 or # 7601. (Part #
8447 is supplied with the
product)
Step 22: Please apply silicone (caulk) sealant at the
connection between both
Aluminum profiles (diagram b), in order to prevent
water from seeping in.
Step 36: Note that panels and profiles are
connected in the right direction and
that the profile holes are placed correctly as
illustrated.
Step 38: Push aluminum profiles against part
#8439 and then use Self-Drilling
screws (4045#) to connect to the profile (Diagram
b). No pre holes is needed.
Step 43: Anchor the shed on to a solid surface such
as concrete or asphalt; use
suitable screws and plugs. (Screws and plugs are
not supplied).
*Please note: Anchoring this product to the
ground is essential to its stability and
rigidity. It is required to complete this stage in order
for your warranty to be valid.
Do not tighten screws and nuts (411 & 412) until
completion of assembly process.
These 2 icons indicate if screws' tightening is
required or not.
A
I
L
-I