Installation Guide

IMPORTANT
Please read these instructions carefully
before you start to assemble this product .
Please carry out the steps in the order set
out in these instructions.
Keep these instructions in a safe place for
future reference.
Safety Advice
For safety purposes we strongly
recommend the product to be assembled by at least 3 people.
Some parts may have sharp edges.
Please be careful when handling components. Always wear
gloves, eye protection, and long
sleeves when assembling or performing any maintenance on
your product.
Do not attempt to assemble the
product in windy or wet conditions.
Do not attempt to assemble the
product if you are tired, have taken drugs,
medications or alcohol, or if you are
prone to dizzy spells.
Dispose of all plastic bags safely -
keep them away from children's reach.
Keep children away from the
assembly area.
When using a stepladder or power
tools, make sure that you are following
the manufacturer's safety advice.
Do not climb or stand on the roof.
Do not hang or lay on the profiles.
Heavy articles should not be leaned
against the poles.
Keep roof and gutters clear of snow,
dirt & leaves.
Heavy snow load on the roof can
make it unsafe to stand below or nearby.
Do not lean against or push the
product during construction.
Hot items such as recently used grills,
blowtorches etc. must not be stored inside the product.
Note: This product must be
anchored on to a leveled surface and solid foundation to ensure its
stability. Make sure that screws and
anchors are compatible with foundation type. Make sure that
there are no obstructions between
the assembly area and the final position.
Cleaning Instructions
In order to clean the product, use a
mild detergent solution and rinse with cold clean water.
Do not use acetone, abrasive
cleaners, or other special detergents to clean the panels.
Clean the product once assembly is
complete.
Before Starting Assembly
Choose your site carefully before
beginning assembly.
The ground surface must be
perfectly flat and leveled and have a solid base such as concrete,
asphalt, deck etc.
Sort the parts and check against the
content parts list.
Parts should be laid out close at
hand. Keep all small parts (screws etc.) in a bowl so they do not
get lost.
Please consult your local authorities
if any permits are required prior to constructing the product.
The drawings in this manual are designed for 11'x 17.2'
shed + 4.1' Extension Kit.
Please note that content list refers only for 11'x 17.2' shed.
11'x 17.2' 4.1'Ext. Kit
11'x21.3'
Yukon + 2x Ext. (11'x 17.2')
Yukon + 3x Ext. (11'x 21.3')
Note: All the extension module steps are marked with a
dashed outline, should be performed
during the product's assembly process.
Optional Accessories
WPC Floor Kit
WPC Floor Kit: If you've
purchased the WPC Floor Kit with the
product, relevant steps are
marked with these icons. If you've
assembled the product
without the floor kit and wish to add
one, please refer to the
relevant steps (marked with these icons)
in the assembly and
perform the necessary adjustments.
Utility Shed Shelf Kit: If you've purchased shelf kits, it is
recommended to insert screws #411
inside the profiles'tracks during the walls'assembly.
Vertical Bicycle Hanger: Can be installed once the product is
fully assembled. Make sure the
bottom wheel is at floor level.