Owner's manual

SUNTUF® Technical Guide

Profile: SUNTUF® Greca 76/16 (Greca/Trapeze)

660, 810, 1040, 1064, 1260, 1870

Profile Drawing

Profile Dimensions

Profile

(mm)

Thickness

(mm)

Length

(m)

Overall width

(mm)

Cover Width

(mm)

Side-Lap

( % )

810 760 6.2

1260 1216 3.4

76 / 16 0.8 1.5 - 11.8

1870 1824 2.4

Load / Span Data

Load (Kg/ m

) 50 80 110

Maximum Roof Span (mm) 1100 1000 900

 The specified dimensions do not supersede the requirements of local construction codes.

 The maximum purlin spans are based on continuous beam calculation model and practical testing.

The criterion for allowed deflections is L/20.

 In vertical walls the spans can be increased by 10%.

 The mentioned load refers to both wind and snow loads.

 Minimum recommended slope – 10%.

 Maximum recommended panel length - 7.0 m.

Curved Roof

 Minimum curving radius 4.0 m.

PAGE 1
SUNTUF® Technical Guide Profile: SUNTUF® Greca 76/16 (Greca/Trapeze) Profile Drawing 660, 810, 1040, 1064, 1260, 1870 Profile Dimensions Profile (mm) 76 / 16 Thickness (mm) 0.8 Length (m) 1.5 - 11.8 Overall width (mm) Cover Width (mm) Side-Lap (%) 810 760 6.2 1260 1216 3.4 1870 1824 2.4 Load / Span Data Load (Kg/ m2) 50 80 110 Maximum Roof Span (mm) 1100 1000 900 The specified dimensions do not supersede the requirements of local construction codes.
PAGE 2
SUNTUF® Technical Guide Profile: SUNTUF® Greca 76/16 (Greca/Trapeze) Positioning Make sure the UV protected side faces out. Side-lap of SUNTUF panels must be installed against the primary direction of rain. The SUNTUF panels must be located and installed without any stresses. Do not pull, stretch or force the sheets when the profiles are not perfectly matched. Fastening Apply sealing tape over the SUNTUF panel side-lap corrugation crests, where covered by the next panel.
PAGE 3
SUNTUF® Technical Guide Profile: SUNTUF® Greca 76/16 (Greca/Trapeze) Important Notes Use only PALRAM approved accessories, including EPDM rubber washers, silicones, sealing tape, closure fixtures etc. For clear SUNTUF onto wooden purlins, apply white acrylic paint, or aluminum tape, in order to prevent over-heating of the purlins. Fastening Tips Use adjustable electric screwdriver. The screw must be installed perpendicular to the SUNTUF sheet. Important: Do not over-tighten.